NIJ Body Armor Standard (original) (raw)

Law Enforcement Agencies Around The Globe Accept NIJ Body Armor Standard

The standard established by the NIJ is widely known and accepted by police agencies throughout the world. Thus, the NIJ standard provides the performance level for most ballistic-resistant vests.
As it stands, there are currently no 100% bulletproof vests available on the market today. However, body armor does provide the wearer a substantial amount of protection from various kinds of handgun ammunition. But, it is imperative that officers be aware that the amount of protection offered varies depending on how a piece body armor is classified and rated in terms of the threat level it protects against.

When officers who perform their duties in certain types of situations – Special Operations officers, SWAT team members and hostage rescuers, face a weapon threat greater than what regular body armor can protect against, they should wear additional protection.

Minimum Requirements for Body Armor

The NIJ standard specifies what the minimum requirements are for body armor that have undergone their performance and testing protocols and rates the various types of available body armor according to the threat levels they offer protection against.

When body armor is undergoing testing, self-regulating NIJ-certified laboratories put the body armor through a number of different tests to ensure they meet NIJ code and performance standards.

The NIJ has the authority to retest body armor that the manufacturer is already selling on its floor to ensure that the performance standards remain up to code as time passes. This is just part of the NIJ’s excellence and audit procedures.

The NIJ’s performance standards means that commercially available body armor meets the minimum performance requirements they set forth. The NIJ publishes their ballistic and stab resistance standards for personal body armor, as you can see here by clicking on these links. An overview of both the NIJ 0101.04 and the NIJ 0101.06 Standards can be found below. The NIJ 0101.07 standard will be published in 2019.

NIJ 0101.04 Standard

Table Ballistic Requirements Penetration / Back Face Signature NIJ 0101.04

Notes NIJ 0101.04 Standard

• Backing is conditioned Roma Plastilina® nr. 1
• Bullet manufacturer is not specified
• All armor panels (including carriers) will be sprayed during three minutes on both sides before testing
• Shape of impact pattern is given, shot 4 and 5 have an impact angle of 30 degrees
• Minimal distance to edge of sample is 76 mm
• Minimal distance to previous impacts is 51 mm

NIJ 0101.06 STANDARD

Table Ballistic Requirements Penetration / Back Face Signature NIJ 0101.06

Notes NIJ 0101.06 STANDARD

• Backing is conditioned Roma Plastilina® nr. 1
• For certification Level IIA, II and IIIA, 28 complete vests must be provided
• For Level III certification, nine armor inserts are required
• For Level IV certification, 7 to 37 armor inserts are required
• All new vests and hard armor plates will be immersed for 30 minutes before testing starts. As per
  section 7.8.2 NIJ STD 0101.06.
• Bullet manufacturer is specified

Receive the latest updates

Fill out your e-mail address below to learn about our latest developments and products.

Contact

EnGarde body armor
P.O. Box 17636
1001 JM
Amsterdam
The Netherlands
P +31 (0)255 517 381
F +31 (0)255 517 797