3. Splitting the AS into Areas (original) (raw)

Connected: An Internet Encyclopedia
3. Splitting the AS into Areas

Up: Connected: An Internet Encyclopedia
Up: Requests For Comments
Up: RFC 1583

Prev: 2.4. TOS-based routing
Next: 3.1. The backbone of the Autonomous System

3. Splitting the AS into Areas

3. Splitting the AS into Areas OSPF allows collections of contiguous networks and hosts to be grouped together. Such a group, together with the routers having interfaces to any one of the included networks, is called an area. Each area runs a separate copy of the basic link-state routing algorithm. This means that each area has its own topological database and corresponding graph, as explained in the previous section.

The topology of an area is invisible from the outside of the area. Conversely, routers internal to a given area know nothing of the detailed topology external to the area. This isolation of knowledge enables the protocol to effect a marked reduction in routing traffic as compared to treating the entire Autonomous System as a single link-state domain.

With the introduction of areas, it is no longer true that all routers in the AS have an identical topological database. A router actually has a separate topological database for each area it is connected to. (Routers connected to multiple areas are called area border routers). Two routers belonging to the same area have, for that area, identical area topological databases.

Routing in the Autonomous System takes place on two levels, depending on whether the source and destination of a packet reside in the same area (intra-area routing is used) or different areas (inter-area routing is used). In intra-area routing, the packet is routed solely on information obtained within the area; no routing information obtained from outside the area can be used. This protects intra-area routing from the injection of bad routing information. We discuss inter-area routing in Section 3.2.

• 3.1. The backbone of the Autonomous System
• 3.2. Inter-area routing
• 3.3. Classification of routers
• 3.4. A sample area configuration
• 3.5. IP subnetting support
• 3.6. Supporting stub areas
• 3.7. Partitions of areas

Next: 3.1. The backbone of the Autonomous System

Connected: An Internet Encyclopedia
3. Splitting the AS into Areas