Running - Dasharo Universe (original) (raw)

The Dasharo Tools Suite can be started in various ways. Currently, there are two options:

• bootable over a network (iPXE),
• bootable USB stick image.

The first one should always be preferred if possible, as it is the easiest one to use.

Bootable over a network

This section describes how to boot DTS using iPXE.

Requirements

Below are the requirements that must be met to run DTS over a network on the platform:

• Dasharo device with DTS functionality integrated,
• wired network connection,
• Secure Boot disabled,
• If device if flashed with Dasharo and support following functionality
  • disabled BIOS lock feature,
  • disabled SMM BIOS write protection feature.

Launching DTS

To access Dasharo Tools Suite:

• attach a wired network cable to the device's Ethernet port,
• power on the device, holding down the Boot Menu entry key,
• in the Boot Menu, select the iPXE Network Boot option,
• in the Network Boot menu, select the Dasharo Tools Suite option, or enter iPXE shell and type by hand:
  dhcp net0 chain https://boot.dasharo.com/dts/dts.ipxe
  Warning
  Because of misconfigured iPXE on some firmware releases, booting over HTTPS is impossible, and the above command will fail. In that case, we recommend downloading the DTS image to USB. If you feel there is no risk of an MITM attack, you can proceed withhttp://boot.dasharo.com/dts/dts.ipxe at your own risk.
• the DTS menu will now appear.

Bootable USB stick

This section describes how to boot DTS using a USB stick.

Requirements

Below are the requirements that must be met to run DTS from a USB device on the platform:

• USB stick (at least 2GB),
• Latest image from releases section.
• Wired network connection,
• Secure Boot disabled,
• If device if flashed with Dasharo and support following functionality
  • disabled BIOS lock feature,
  • disabled SMM BIOS write protection feature.

Launching DTS

To access Dasharo Tools Suite:

• flash the downloaded image onto USB stick,
  • you can use a cross-platform GUI installer - Etcher
  • you can also use dd to flash from the command line

gzip -cdk dts-base-image-v1.1.0.wic.gz | \ sudo dd of=/dev/sdX bs=16M status=progress conv=fdatasync

Notes

• this is an example done on the v1.1.0 image.

• replace "sdX" with the letter of your USB disk device. For example: sda, sdb, sdc. It should not be partition number (for example, not sda1 or sda2).

• insert the USB stick into a USB in your device,

• boot from the USB stick,

• the DTS menu will now appear.