DIY Clay & Rope Pot | Fall For DIY (original) (raw)
You can never have enough pretty pots to fill with pretty things right? In our case we never seem to have enough fruit bowls for all the fruit we need! Especially it this weather when there’s nothing better than a fresh, cold fruit juice to wake you up in the morning. We need more room for the oranges! In true DIY style we make some. I’m using this pot for my fruit, but you can use it for anything you like. See the end of this post for some more ideas.
Materials
Air dry clay | Bowl | Roller | Thin Straw | Needle | Rope | Embroidery Floss
Roll out the clay and gently lift into the bowl. Press it into place with your fingertips gathering all the extra clay to one point. Cut off the excess lump of clay and all of the clay around the edge of the bowl. Get yourself a small bowl of water and start smoothing out all the lumps, creases and cracks.
At the point where you cut away the excess clay carefully pull the clay away from the edge of the bowl. Smooth over the join the push back into place. Keep smoothing until you’re happy.
Using the flat end of the straw make holes around the edge of the bowl and leave the clay to dry out.
Once the clay has fully dried out remove the pot from the bowl. If there are any obvious cracks or creases roll out a thin layer of clay and smooth over the area using a wet make-up sponge to smooth into the clay. Leave it to dry again and sand until smooth.
Cut off a long piece of embroidery thread and thread on the needle. Sew it through each of the holes in the bowl and around the rope. Once the rope is wrapped around the bowl one whole time, thread the floss under the last row of rope and over the new layer.
Continue until you’re happy with the height of the bowl and finish at the same point you had started. Tie off the thread and cut off the excess rope.
Next up, I’m making a tall, thin vase building the clay around a thin glass jar and following the steps as above.