Ahmed Nasser - Academia.edu (original) (raw)
Uploads
Papers by Ahmed Nasser
Journal of Materials Processing Technology, 2010
Room temperature uniaxial tensile and biaxial Viscous Pressure Bulge (VPB) tests were conducted f... more Room temperature uniaxial tensile and biaxial Viscous Pressure Bulge (VPB) tests were conducted for five Advanced High Strength Steels (AHSS) sheet materials, and the resulting flow stress curves were compared. Strain ratios (R-values) were also determined in the tensile test and used to correct the biaxial flow stress curves for anisotropy. The pressure vs. dome height raw data in the VPB test was extrapolated to the burst pressure to obtain the flow stress curve until fracture. Results of this work show that the flow stress data can be obtained to higher strain values under biaxial state of stress. Moreover, it was observed that some materials behave differently if subjected to different state of stress. These two conclusions, and the fact that the state of stress in actual stamping processes is almost always biaxial, suggest that the bulge test is a more suitable test for obtaining the flow stress of AHSS sheet materials for use as an input to Finite Element (FE) simulation models.
Environmental Science & Technology, 2008
We tested the possibility of using tree cores to detect unknown subsurface contamination by chlor... more We tested the possibility of using tree cores to detect unknown subsurface contamination by chlorinated volatile organic compounds (Cl-VOCs) and petroleum hydrocarbons, a method we term "phytoscreening". The scope and limitations of the method include the following: (i) a number of widespread Cl-VOC contaminants are readily found in tree cores, although those with very high vapor pressures or low boiling points may be absent; (ii) volatile petroleum hydrocarbons were not wellexpressed in tree cores; (iii) trees should be sampled during active evapotranspiration and from directions that are well exposed to sunlight; (iv) there is not necessarily a direct correlation between concentrations measured in tree cores and those in the subsurface; (v) detection of a contaminant in a tree core indicates that the subsurface is contaminated with the pollutant; (vi) many possible causes of false negatives may be predicted and avoided. We sampled trees at 13 random locations in the Tel Aviv metropolitan area and identified Cl-VOCs in tree cores from three locations. Subsequently, subsurface contamination at all three sites was confirmed. Phytoscreening is a simple, fast, noninvasive, and inexpensive screening method for detecting subsurface contamination, and is particularly useful in urban settings where conventional methods are difficult and expensive to employ.
Environmental Technology, 2012
The presence of an ionized carboxyl group in the widely used non-steroidal anti-inflammatory (NSA... more The presence of an ionized carboxyl group in the widely used non-steroidal anti-inflammatory (NSAID) drug diclofenac potassium results in a high mobility of diclofenac and in its low sorption under conditions of slow sand filtration or subsoil passage. No diclofenac degradation was detected in pure water or sludge during one month. Tertiary treatments of wastewater indicated that the effective removal of diclofenac was by reverse osmosis, but the removal by activated carbon was less satisfactory. This study presents an efficient method for the removal of diclofenac from water by micelle-clay composites that are positively charged, have a large surface area and include large hydrophobic domains. Adsorption of diclofenac in dispersion by charcoal and a composite micelle (otadecyltrimethylammonium [ODTMA] and clay [montmorillonite]) was investigated. Analysis by the Langmuir isotherm revealed that charcoal had a somewhat larger number of adsorption sites than the composite, but the latter had a significantly larger binding affinity for diclofenac. Filtration experiments on a solution containing 300 ppm diclofenac demonstrated poor removal by activated carbon, in contrast to very efficient removal by micelle-clay filters. In the latter case the weight of removed diclofenac exceeded half that of ODTMA in the filter. Filtration of diclofenac solutions at concentrations of 8 and 80 ppb yielded almost complete removal at flow rates of 30 and 60 mL min(-1). One kilogram of ODTMA in the micelle-clay filter has been estimated to remove more than 99% of diclofenac from a solution of 100 ppb during passage of more than 100 m3.
Journal of Materials Processing Technology, 2010
Room temperature uniaxial tensile and biaxial Viscous Pressure Bulge (VPB) tests were conducted f... more Room temperature uniaxial tensile and biaxial Viscous Pressure Bulge (VPB) tests were conducted for five Advanced High Strength Steels (AHSS) sheet materials, and the resulting flow stress curves were compared. Strain ratios (R-values) were also determined in the tensile test and used to correct the biaxial flow stress curves for anisotropy. The pressure vs. dome height raw data in the VPB test was extrapolated to the burst pressure to obtain the flow stress curve until fracture. Results of this work show that the flow stress data can be obtained to higher strain values under biaxial state of stress. Moreover, it was observed that some materials behave differently if subjected to different state of stress. These two conclusions, and the fact that the state of stress in actual stamping processes is almost always biaxial, suggest that the bulge test is a more suitable test for obtaining the flow stress of AHSS sheet materials for use as an input to Finite Element (FE) simulation models.
Environmental Science & Technology, 2008
We tested the possibility of using tree cores to detect unknown subsurface contamination by chlor... more We tested the possibility of using tree cores to detect unknown subsurface contamination by chlorinated volatile organic compounds (Cl-VOCs) and petroleum hydrocarbons, a method we term "phytoscreening". The scope and limitations of the method include the following: (i) a number of widespread Cl-VOC contaminants are readily found in tree cores, although those with very high vapor pressures or low boiling points may be absent; (ii) volatile petroleum hydrocarbons were not wellexpressed in tree cores; (iii) trees should be sampled during active evapotranspiration and from directions that are well exposed to sunlight; (iv) there is not necessarily a direct correlation between concentrations measured in tree cores and those in the subsurface; (v) detection of a contaminant in a tree core indicates that the subsurface is contaminated with the pollutant; (vi) many possible causes of false negatives may be predicted and avoided. We sampled trees at 13 random locations in the Tel Aviv metropolitan area and identified Cl-VOCs in tree cores from three locations. Subsequently, subsurface contamination at all three sites was confirmed. Phytoscreening is a simple, fast, noninvasive, and inexpensive screening method for detecting subsurface contamination, and is particularly useful in urban settings where conventional methods are difficult and expensive to employ.
Environmental Technology, 2012
The presence of an ionized carboxyl group in the widely used non-steroidal anti-inflammatory (NSA... more The presence of an ionized carboxyl group in the widely used non-steroidal anti-inflammatory (NSAID) drug diclofenac potassium results in a high mobility of diclofenac and in its low sorption under conditions of slow sand filtration or subsoil passage. No diclofenac degradation was detected in pure water or sludge during one month. Tertiary treatments of wastewater indicated that the effective removal of diclofenac was by reverse osmosis, but the removal by activated carbon was less satisfactory. This study presents an efficient method for the removal of diclofenac from water by micelle-clay composites that are positively charged, have a large surface area and include large hydrophobic domains. Adsorption of diclofenac in dispersion by charcoal and a composite micelle (otadecyltrimethylammonium [ODTMA] and clay [montmorillonite]) was investigated. Analysis by the Langmuir isotherm revealed that charcoal had a somewhat larger number of adsorption sites than the composite, but the latter had a significantly larger binding affinity for diclofenac. Filtration experiments on a solution containing 300 ppm diclofenac demonstrated poor removal by activated carbon, in contrast to very efficient removal by micelle-clay filters. In the latter case the weight of removed diclofenac exceeded half that of ODTMA in the filter. Filtration of diclofenac solutions at concentrations of 8 and 80 ppb yielded almost complete removal at flow rates of 30 and 60 mL min(-1). One kilogram of ODTMA in the micelle-clay filter has been estimated to remove more than 99% of diclofenac from a solution of 100 ppb during passage of more than 100 m3.