Anmol Arora - Academia.edu (original) (raw)
Uploads
Papers by Anmol Arora
INTERNATIONAL JOURNAL OF ADVANCE RESEARCH, IDEAS AND INNOVATIONS IN TECHNOLOGY
This paper represents the experimentation of the Vortex Tube Refrigeration system. Vortex tube al... more This paper represents the experimentation of the Vortex Tube Refrigeration system. Vortex tube also is known as Ranque-Hilsch Vortex tube. A Vortex Tube is a Mechanical Device, which generates cold and hot streams from a single injection of pressurized gas. Without any moving parts or chemical reaction within the tube, the intersecting phenomenon of energy separation results only from fluid dynamic effects. The Control valve is a screw located at the hot end and cold end with thread on it which is used to restrict the flow of air due to which the small forced vortex takes place after stagnation point and free vortex getaway through the hot end as hot air and cold end as cold air. At the other end, a small orifice plate is located to further reduce the temperature Drop. The 2.5 HP compressors are used for experimentation for low pressures. Also, for higher pressures, it is difficult with a low capacity compressor to get accurate results. For this purpose, a model has been developed using experimental data to predict the results for the pressure range of 1to 6 bar. We have attached the Thermo-electric module to the system to generate electricity without affecting the efficiency of the system.
INTERNATIONAL JOURNAL OF ADVANCE RESEARCH, IDEAS AND INNOVATIONS IN TECHNOLOGY
This paper represents the experimentation of the Vortex Tube Refrigeration system. Vortex tube al... more This paper represents the experimentation of the Vortex Tube Refrigeration system. Vortex tube also is known as Ranque-Hilsch Vortex tube. A Vortex Tube is a Mechanical Device, which generates cold and hot streams from a single injection of pressurized gas. Without any moving parts or chemical reaction within the tube, the intersecting phenomenon of energy separation results only from fluid dynamic effects. The Control valve is a screw located at the hot end and cold end with thread on it which is used to restrict the flow of air due to which the small forced vortex takes place after stagnation point and free vortex getaway through the hot end as hot air and cold end as cold air. At the other end, a small orifice plate is located to further reduce the temperature Drop. The 2.5 HP compressors are used for experimentation for low pressures. Also, for higher pressures, it is difficult with a low capacity compressor to get accurate results. For this purpose, a model has been developed using experimental data to predict the results for the pressure range of 1to 6 bar. We have attached the Thermo-electric module to the system to generate electricity without affecting the efficiency of the system.