Video hardware connectors pinouts diagrams @ pinoutguide.com (original) (raw)
3 pin XLR connector The XLR connectors are used mostly in professional audio and video electronics cabling applications. Home audio and video electronics normally use RCA connectors. There is no common pinout - it's depends on application.
5 pin XLR connector The XLR connectors are used mostly in professional audio and video electronics cabling applications. There is no common pinout - it's depends on application
Camera Link interface Camera Link is a standard interface used in industrial cameras. It consists of a number of serial links using differential signaling. Depending on the amount of data to be transferred, one or two cables can be used per camera.
RCA connector An RCA cable/connector (also phono connector or Cinch connector) used to transmit analog audio and composite-video signals between devices such as TV, satellite, cable receivers, VCRs, game console systems, speakers and more. The connectors are also sometimes referred as A/V jacks.
S-Video S-Video is commonly used in many consumer TVs, DVD players, video tape recorders, game consoles and almost all TV-out connectors of graphics cards.
Y Adapter XLR to 2x Mono Jack (Stereo) This adapter came from the necessity to connect two mono outputs (left and right) from a mixer to a xlr male connector in a 10ft snake.
Aiptek Pico Projector 5V Mini USB Power supply lead Aiptek Pico Projector uses a non standard Mini USB connector, when using a standard USB lead, the projector charges but will not turn on but will connect to a computer in mass storage device. If you need to connect to a 5V supply to charge and power at the same time the 5V power is supplied to pin x instead of pin 1 as standard.
Alpine Pinouts
Alpine Bass Knob for MRD-M300 and MRD-M500 Amps Connect a 5k potentiometer between pins 2 and 6. 5k=Full Volume, 0 Ohm =Minimum Volume Note the odd pinout of a 7 pin DIN connector. Facing the amp, clockwise starting on the bottom left: 6,1,4,2,5,3,7 Pot connects to bottom left and top pins.
Altec Pinouts
Altec Lansing BX1121 Right satellite connector located at the rear of the subwoofer.
ATI Radeon VGA to TV cable allows to connect ATI VGA to TV SCART. ATI RADEONs and some old Matrox card can generate a
CheckPoint Pinouts
CheckPoint Firewall UTM-1 570 (U-20) internal VGA connector The CheckPoint UTM-1 Has a standard vga output (it is a pc with big ass network interfaces :)) Video signal was easy, measured 75ohms to ground with the multimeter and V H sync signals figured it out with the oscilloscope 31Khz and 60Hz, the only difficult was SDA and SCL signals, since i have to no way to know it at the motherboard side, i take a gamble and connected it trough a 330ohms resistor to the vga 15 pin connector (in case i got it wrong), here it is. it is easy to see if SDA/SCL is reversed because monitor will not be identified by the video card, if that happens, reverse it and that's it, remember to use 330ohms in series between the IDC connector output and the vga, in both lines, it is not really necessary but a good measure to protect the monitor.
E-MU 0404 Analog In/Out Pinout Analog In-/Output E-MU 0404.The breakout cable for analog in-/output of the E-MU 0404 is terminated on soundcard side with a regular male SUB-D
Logitech x-530 audio Connector The 15 Pin connector from the Subwoofer to the Front Right Speaker. All other speakers are connected by a phono lead except front right which uses has the following layout.
Logitech x-530 Front Right Connector The 15 Pin connector from the Subwoofer to the Front Right Speaker. All other speakers are connected by a phono lead except front right which uses has the following layout.
Magnavox FM Transmitter MXC012 The unit claims to be compatible with iPod & iPhone, more correctly it shares its pinout with HTC & HD2 phones.
Martin Pinouts
Martin Lightjockey DMX card PC DMX pinout for Martin Lightjockey interface card - common for profesional lighting use the Martin professional Lightjockey software with DMX interface, this are the pinout for the one (512ch) or four (2048ch) universes corresponding to the version dj or club.
Osprey capture cards universal breakout From Osprey Knowledge Base: "If you wish to make your own break out connectors, the pin out is below for the DB15 connector. Your card may not make use of all the pins. This is a universal breakout for Osprey capture cards."
Panasonic Pinouts
Panasonic NV-MC5 adaptor Pin-out of the 8 pins connector of the Panasonic NV-MC5 VHS-C camcorder.
Sanyo VM-H100 Hi8 Camcorder AV Cable This is the end of the proprietary Sanyo camcorder cable that plugs into the camera itself via a DIN connector. The other end for the TV is just standard RCA connectors (Mono audio only). Pinout determined using continuity on multimeter.
