Indication of Unusual Pentagonal Structures in Atomic-Size Cu Nanowires (original) (raw)
Related papers
Electrochemical formation of quantum-conductance Cu-metal nanobridges
Russian Journal of Electrochemistry, 2008
The electrodeposition of copper with formation of narrow nanobridge contacts was investigated. Stable quantum nanobridges (QNB) with ballistic conductance have been obtained by pulsed Cu deposition/electroetching on Cr interdigitated microelectrodes nanolithographed on a quartz wafer. The minimum quantum conductance associated with monatomic-wide constriction in the nanobridge was observed. Stepped differential conductance G = ng 0 (where g 0 is the minimum quantum conductance and n = 1, 2, 3, …) was generally observed although fractional multiples of g o were also found, likely due to the deviations of the nanowire junction geometry from linear configuration and reflection losses. In the layer-by-layer Cu deposition/etching technique employed for junction formation, the current amplification associated with interdigitated electrode pattern was utilized, which allowed us for easy electrochemical control with no need for special instrumentation. Quantum mechanical calculations of the electronic structure of Cu-QNB have been carried out using small-cluster approach with configuration 14m -14 , where m denotes the number of Cu atoms in the monatomic-wide bridge, and the base electrodes are simulated by clusters with 14 Cu atoms each. The calculations performed for m = 1 to 4, indicate that corrugations of electron density along the conductance channel virtually disappear for m = 3, whereas for even number of Cu atoms in the bridge, a distinct, very narrow constriction is formed in the center of the bridge. These results corroborate earlier findings for alkali metals, for which considerable differences between odd and even number of atoms in a monatomic-wide conductance channel have been reported.
Electrical Properties of Cu Nanowires
2008 8th IEEE Conference on Nanotechnology, 2008
Copper nanowires were patterned with e-beam lithography and fabricated with an e-beam evaporated Cu film. Electrical properties, including resistivity and temperature coefficient of resistance, were characterized for Cu nanowires with a width range of 90 nm to 330 nm. It was experimentally found that the surface and size have apparent influence on the electrical properties. The measured resistivity of the Cu nanowires was found to be size dependent, which was in good agreement with the theoretical models. In addition, smaller values of the temperature coefficient of resistance were experimentally found as the wire width decreases for the Cu nanowires. The size dependent nature of the temperature coefficient of resistance was attributed to the surface and size effects based on the further demonstrative analysis. Same as Report (SAR) 18. NUMBER OF PAGES 4 19a. NAME OF RESPONSIBLE PERSON
In Situ Investigation of Defect-Free Copper Nanowire Growth
Nano letters, 2018
The fabrication and placement of high purity nanometals, such as one-dimensional copper (Cu) nanowires, for interconnection in integrated devices have been among the most important technological developments in recent years. Structural stability and oxidation prevention have been the key issues, and the defect control in Cu nanowire growth has been found to be important. Here, we report the synthesis of defect-free single-crystalline Cu nanowires by controlling the surface-assisted heterogeneous nucleation of Cu atomic layering on the graphite-like loop of an amorphous carbon (a-C) lacey film surface. Without a metal-catalyst or induced defects, the high quality Cu nanowires formed with high aspect ratio and high growth rate of 578 nm/s. The dynamic study of the growth of heterogeneous nanowires was conducted in situ with a high-resolution transmission electron microscope. The study illuminates the new mechanism by heterogeneous nucleation control and laying the groundwork for bette...
Strain Relief Guided Growth of Atomic Nanowires in a Cu3NCu(110) Molecular Network
Physical Review Letters, 2009
A self-corrugated Cu3N-Cu(110) molecular network shows potential to overcome the element dependence barrier as demonstrated by epitaxial growth of atomic nanowires (∼ 1 nm in width) among various 3d, 4d, and 5d elements. Scanning tunnelling microscopy (STM) shows that all of the investigated atomic nanowires share an identical structure, featuring uniform width, height, orientation and same minimum separation distance. Ab initio study reveals that the formation mechanism of atomic nanowires can be directly attributed to a strain relief guided asymmetric occupation of atoms on the originally symmetric crest zone of the corrugated network.
Defects in ultrathin copper nanowires: Atomistic simulations
Physical Review B, 2002
We have performed atomistic simulations for cylindrical multi-shell (CMS)-type Cu nanowires containing defects. Our investigation has revealed some physical properties that have not been detected in previous studies that have considered defect-free nanowires. Since the vacancy formation energy is lowest in the core of a CMS-type nanowire, a vacancy formed in the outer shell of a CMS-type nanowire naturally migrates toward the core. The maximum of the formation energy of an adhered atom on the surface of a CMS-type nanowire was modeled using a 16-11-6-1 nanowire. The formation energy of an adhered atom decreased when the diameter of the CMS-type nanowire was either above or below the diameter of the peak energy maximum. This investigation found three recombination mechanisms for the vacancy-adhered atom pairs: (i) by direct recombination, (ii) by a kick-in recombination, and (iii) by a ring recombination. Vacancy formation energy calculations show that an onion-like cluster with a hollow was formed, and molecular dynamics simulations for various CMS-type nanowires found that vacancies migrated towards the core. From these, we obtained basic information on the formation of hollow CMS-type metal nanowires (metal nanotubes) [Y. Oshima, et al., Phys.
Electron transport properties of sub-3-nm diameter copper nanowires
Physical Review B, 2015
Density functional theory and density functional tight binding are applied to model electron transport in copper nanowires of approximately 1-and 3-nm diameters with varying crystal orientation and surface termination. The copper nanowires studied are found to be metallic irrespective of diameter, crystal orientation, and/or surface termination. Electron transmission is highly dependent on crystal orientation and surface termination. Nanowires oriented along the [110] crystallographic axis consistently exhibit the highest electron transmission while surface oxidized nanowires show significantly reduced electron transmission compared to unterminated nanowires. Transmission per unit area is calculated in each case; for a given crystal orientation we find that this value decreases with diameter for unterminated nanowires but is largely unaffected by diameter in surface oxidized nanowires for the size regime considered. Transmission pathway plots show that transmission is larger at the surface of unterminated nanowires than inside the nanowire and that transmission at the nanowire surface is significantly reduced by surface oxidation. Finally, we present a simple model which explains the transport per unit area dependence on diameter based on transmission pathways results.
Ordered versus disordered growth of copper quantum wires on Mo and W vicinal surfaces
2003
We present first-principles calculations elucidating the different self-assembly mode of Cu nanowires on vicinal surfaces of Mo (ordered ''one-dimensional''growth) and W (rough, disordered growth). The severe differences in growth mode despite the decided similarity between the substrates is linked to subtle electronicstructure coupling effects between substrate and adsorbate, while kinetics and stress effects are found to be immaterial.
Self-assembly of conductive Cu nanowires on Si(111)‘5 × 5 ’-Cu surface
Nanotechnology, 2008
Upon room-temperature deposition onto a Cu/Si(111)'5 × 5' surface in ultra-high vacuum, Cu atoms migrate over extended distances to become trapped at the step edges, where they form Cu nanowires (NWs). The formed NWs are 20-80 nm wide, 1-3 nm high and characterized by a resistivity of ∼8 μ cm. The surface conductance of the NW array is anisotropic, with the conductivity along the NWs being about three times greater than that in the perpendicular direction. Using a similar growth technique, not only the straight NWs but also other types of NW-based structures (e.g. nanorings) can be fabricated.
The crystal structure and growth direction of Cu2S nanowire arrays fabricated on a copper surface
Physical Chemistry Chemical Physics, 2001
We examine the crystal structure and growth direction of nanowire arrays grown from copper surfaces at Cu 2 S room temperature. By using X-ray di †raction (XRD), transmission electron microscopy (TEM) and electron di †raction (ED) techniques, the monoclinic nanowires are shown to grow preferentially along the c-axis, Cu 2 S characterized by a layered structure. This result may shed light on the unusual growth mechanism of the Cu 2 S nanowires.
Physical Review B, 2006
We report high resolution transmission electron microscopy and classical molecular dynamics simulation results of mechanically stretching copper nanowires conducting to linear atomic suspended chains (LACs) formation. In contrast with some previous experimental and theoretical work in literature that stated that the formation of LACs for copper should not exist our results showed the existence of LAC for the [111], [110], and [100] crystallographic directions, being thus the sequence of most probable occurence.