Control of Nonlinear Networked Systems With Packet Dropouts: Interval Type-2 Fuzzy Model-Based Approach (original) (raw)
Related papers
H∞ Control of Uncertain Fuzzy Networked Control Systems with State Quantization
Intelligent Control and Automation
The problem of robust control for uncertain discrete-time Takagi and Sugeno (T-S) fuzzy networked control systems (NCSs) is investigated in this paper subject to state quantization. By taking into consideration network induced delays and packet dropouts, an improved model of network-based control is developed. A less conservative delay-dependent stability condition for the closed NCSs is derived by employing a fuzzy Lyapunov-Krasovskii functional. Robust fuzzy controller is constructed that guarantee asymptotic stabilization of the NCSs and expressed in LMIbased conditions. A numerical example illustrates the effectiveness of the developed technique.
Fuzzy Logic Controller for Networked Control Systems with Packet Losses
International Conference on Aerospace Sciences and Aviation Technology
Networks and their applications have been evolving substantially in the last two decades. Networked Control Systems (NCS) are one of the hottest topics in networkbased applications. By networked control system we mean controlling the system through the network. Such systems offer advantages such as lower installation costs, increased flexibility, reliability, also reduced maintenance costs. The change of communication architecture from point-to-point to this common bus approach, however, introduces different forms of loss of packets in the closed-loop system dynamics. These packets loss comes from node failures or message collisions.
This study presents a two-level Quasi T-S fuzzy (QTS) model to represent nonlinear networked control systems (NCS), which takes the performance of network with time-delay and data packet dropouts into the investigations. At the working points of nonlinear NCS, regard the subsystem as linear system modelling by QTS, then the global model of nonlinear is fuzzy fused by linear subsystem. This study constructs the corresponding system model, in which the system's stability is proved with linear matrix inequality (LMI). As a bench test a nonlinear system is selected to demonstrate the feasibility and efficiency though numerical analysis. This study provides a new method of fault diagnosis and tolerance control of nonlinear NCS.
Filtering of Interval Type-2 Fuzzy Systems With Intermittent Measurements
IEEE transactions on cybernetics, 2015
In this paper, the problem of fuzzy filter design is investigated for a class of nonlinear networked systems on the basis of the interval type-2 (IT2) fuzzy set theory. In the design process, two vital factors, intermittent data packet dropouts and quantization, are taken into consideration. The parameter uncertainties are handled effectively by the IT2 membership functions determined by lower and upper membership functions and relative weighting functions. A novel fuzzy filter is designed to guarantee the error system to be stochastically stable with H∞ performance. Moreover, the filter does not need to share the same membership functions and number of fuzzy rules as those of the plant. Finally, illustrative examples are provided to illustrate the effectiveness of the method proposed in this paper.
Robust Quantized Approach to Fuzzy Networked Control Systems
IEEE Journal on Emerging and Selected Topics in Circuits and Systems, 2012
This paper investigates the problem of robust control for uncertain discrete-time Takagi-Sugeno (T-S) fuzzy networked control systems (NCSs) with state quantization. A new model of network-based control with simultaneous consideration of network induced delays and packet dropouts is proposed. Using fuzzy Lyapunov-Krasovskii functional, we derive a less conservative delay-dependent stability condition for the closed NCSs. Robust fuzzy controller is developed for the asymptotic stabilization of the NCSs and expressed in linear matrix inequality-based conditions. Numerical simulation examples show the feasibility applications of the developed technique.
Controller Design for Networked Fuzzy Systems
2006 6th World Congress on Intelligent Control and Automation, 2006
This paper deals with the problem of networkbased controller design for the given T-S fuzzy model. The effects of both network-induced delays which are assumed to be interval time-varying, and data packet dropout will be investigated. Based on an integral inequality and a matrix inequality, a delay-dependent sufficient condition for the existence of a network-based controller is formulated in terms of a linear matrix inequality by adjusting two parameter matrices. And no model transformation is employed. Moreover, in order to obtain a less conservative design method of the network-based controller by solving the obtained nonlinear matrix inequalities and to avoid adjusting any parameter matrix, a novel iterative algorithm is proposed. An illustrative numerical example is also given to show the effectiveness of the proposed design method.
Improved Takagi-Sugeno fuzzy output tracking control for nonlinear networked control systems
Journal of the Franklin Institute, 2017
This paper deals with the output tracking control problem for nonlinear networked control systems (NCSs) described by Takagi-Sugeno (T-S) fuzzy models. Due to the existence of inherent constraints in NCS as communication time-delays and limitation of data transmission capacity, a recent event-triggered scheme proposed in the literature is implemented to reduce the bandwidth utilization. On the other hand, the communication timedelay imposes an asynchronously operation between the proposed T-S fuzzy controller and the T-S fuzzy system handled via new LMI based conditions. Furthermore, a synchronous model operation is also proposed in this paper which allows to design a linear controller which is much simpler to implement. The main results are derived following the selection of an appropriate fuzzy Lyapunov Krasovskii Functional (LKF) together with alternative integral inequalities which lead to less conservative conditions when compared to recent results in the literature. An example illustrates the effectiveness of the proposed output tracking control for NCSs fuzzy models.
Stability analysis of interval type-2 fuzzy-model-based control systems
Systems, Man, and Cybernetics, Part …, 2008
This paper presents the stability analysis of interval type-2 fuzzy-model-based (FMB) control systems. To investigate the system stability, an interval type-2 Takagi-Sugeno (T-S) fuzzy model, which can be regarded as a collection of a number of type-1 T-S fuzzy models, is proposed to represent the nonlinear plant subject to parameter uncertainties. With the lower and upper membership functions, the parameter uncertainties can be effectively captured. Based on the interval type-2 T-S fuzzy model, an interval type-2 fuzzy controller is proposed to close the feedback loop. To facilitate the stability analysis, the information of the footprint of uncertainty is used to develop some membership function conditions, which allow the introduction of slack matrices to handle the parameter uncertainties in the stability analysis. Stability conditions in terms of linear matrix inequalities are derived using a Lyapunov-based approach. Simulation examples are given to illustrate the effectiveness of the proposed interval type-2 FMB control approach.
Model-based fuzzy control results for networked control systems
Reports in Mechanical Engineering, 2020
This paper discusses aspects concerning the design of model-based fuzzy controllers for Networked Control Systems (NCSs). The stability analysis is related to the characteristic equation of these control systems, where the variable time delays create numerical problems. These numerical problems are first briefly investigated, along with signal processing aspects concerning NCSs. The popular Hilbert-Huang transform is applied to smooth the signals and also the variable time delay, also called latency, due to the communication in the network. The design of Takagi-Sugeno-Kang Proportional-Integral-fuzzy controllers dedicated to temperature control applications is next carried out; the stability of fuzzy NCSs is guaranteed by computing the controller tuning parameters as solutions to linear matrix inequalities. Experimental results for a laboratory equipment that models a first-order plus time delay process are included to validate the theoretical findings.