Diffusion in glassy polymers: A model using a homogenization method and the effective medium theory (original) (raw)
Related papers
Gas Transport in Glassy Polymers: Prediction of Diffusional Time Lag
Membranes
The transport of gases in glassy polymeric membranes has been analyzed by means of a fundamental approach based on the nonequilibrium thermodynamic model for glassy polymers (NET-GP) that considers the penetrant chemical potential gradient as the actual driving force of the diffusional process. The diffusivity of a penetrant is thus described as the product of a purely kinetic quantity, the penetrant mobility, and a thermodynamic factor, accounting for the chemical potential dependence on its concentration in the polymer. The NET-GP approach, and the nonequilibrium lattice fluid (NELF) model in particular, describes the thermodynamic behavior of penetrant/polymer mixtures in the glassy state, at each pressure or composition. Moreover, the mobility is considered to follow a simple exponential dependence on penetrant concentration, as typically observed experimentally, using only two adjustable parameters, the infinite dilution penetrant mobility L10 and the plasticization factor β, b...
Gas Diffusion in Glassy Polymers by a Chain Relaxation Approach
Macromolecules, 2003
Plasticization of glassy polymers by small molecules was approached by the "concentrationtemperature superposition" principle. The major effect of the plasticization by small molecules is on the reduction of the glass transition temperature. The present study suggests that the dependence of diffusion coefficients of small molecules on the penetrant concentration can be affected by the reduction of the glass transition of the penetrant/polymer system caused by a plasticization effect of the penetrant. With a WLF type shift factor, the concentration-dependent diffusion coefficient can be predicted. It is found that the calculated diffusion coefficient correlates very well to the experimental data. This study also proposes a prediction of time-lag values from the solubility and permeability measurements. Moreover, the diffusion coefficients for gases in glassy polymers can also be predicted using the time-lag values alone. The proposed diffusion model represents satisfactorily experimental data reported in the literature for CO 2 in poly(ethylene terephthalate), in polycarbonate, and in polyacrylate. The prediction of diffusion coefficient in glassy polymers is seen to agree well with the experimental data, whereas the prediction of time-lag values is less accurate due to the error propagation in solubility measurement, permeability measurement, and time-lag measurement, respectively.
Effect of microheterogeneities on the diffusion of gases through glassy polymers
Journal of Polymer Science Part B: Polymer Physics, 1990
The diffusion of gases through glassy polymers is studied and the effective diffusion coefficient D ' " is represented as the result of the superposition of two fundamental mechanisms, namely slipping and hopping. De" is calculated by a two-point correlation method. Comparisons are made with experimental data of Meares for diffusion coefficients of Kr, O,, He, and A in poly(viny1 acetate) in the glassy state. Good fits are obtained and yield significant parameters.
Journal of Membrane Science, 1998
Three types of novel correlations for activation energies of gas permeation E P and diffusion E D in amorphous glassy polymers are considered and their application for prediction of the E P and E D values for different gases are examined. The ®rst one is based on application of the group contribution method. Combined consideration of the equation of free volume and Arrhenius equation results in the correlation of E P and E D with free volume V f and fractional free volume (FFV). At last, the correlations between E P and the permeability coef®cient at a certain reference temperature P(T ref ), as well as E D versus D(T ref ), are based on the ful®lment of the so-called compensation effect between activation energies and preexponential factors in activated processes. Examples of applicability of the correlations considered and recommendations for their use in prediction of the E P and E D values are given for transport of various gases in glassy polymers and separately in amorphous glassy polyimides. #
Gas diffusion in partially crystalline polymers part I: Concentration dependence
Journal of Polymer Science Part B: Polymer Physics, 1996
In this work, a phenomenological model for the gas diffusion in partially crystalline polymers using differential effective medium theory is presented. By making an analogy with the power law known as Archie's law which relates the d.c. conductivity of a brine saturated porous rock to its porosity; we show that gas diffusion through semicrystalline polymers can be described in a similar way. It is assumed that the diffusion coefficient in the crystalline region is zero, while in the amorphous region it is given by a free volume model, and an effective diffusion coefficient Deff, is obtained using the mentioned analogy. The variation of Deff upon concentration is analyzed through its free volume dependence. The crystallinity dependence is considered through an average chain immobilization factor (p), which is explicitely derived. Finally, the results of this model are compared with experimental data given by Kreituss and Frisch, obtaining a good agreement. 0 1996 John Wiley & Sons, Inc. Keywords: diffusion through polymeric films Archie's law effective medium theory concentration dependence Geophysics, 4 3 , 1 2 5 0 (1978).
On the diffusion of gases in partially crystalline polymers
Journal of Polymer Science Part B: Polymer Physics, 1989
The diffusion of gases through partially crystalline polymers is studied. The effective diffusion coefficient DeB is obtained as the result of the averaged superposition of two fundamental mechanisms, namely, diffusion through the crystallites is considered to be zero, and diffusion through the rubbery fraction of the polymer obeys a Fujita-like free-volume theory. The predicted Deff is compared with experimental data of Kreituss and Frisch. The behavior of the diffusion coefficient in terms of concentration and crystalline fraction is satisfactorily explained through the model.
A Free Volume Distribution Model of Gas Sorption and Dilation in Glassy Polymers
Macromolecules, 1995
A new approach is employed to model the sorption of gases in glassy polymers. The dualmode concept that sorption occurs in both "equilibrium" (Henry's law) sites and "nonequilibrium" (Langmuir) sites is used to separate the two contributions. The Sanchez-Lacombe equation of state is applied to predict the sorption in the Henry's law region of the polymer matrix. Characteristic parameters for the polymer liquid are used at glassy temperatures to provide a description of sorption in a hypothetical "equilibrium" state. The additional contribution provided by sorption into the regions of excess free volume that arise from the glassy state is addressed using a modified version of an approach first proposed by Kirchheim. The excess free volume is presumed to exist in a distribution of sizes, which in turn gives rise to a distribution of sorption energies. Positron annihilation lifetime spectroscopy data are used in conjunction with PVT data to characterize the glassy polymer. This independent description of the glassy state is then used to calculate the Langmuir-type sorption. The resulting model uses only one adjustable parameter to provide excellent descriptions of the sorption of several gases in three polycarbonates, as well as the volume dilation caused by the sorbed gas.
Transient and steady-state effective diffusivity in high free volume glassy polymers
Journal of Membrane Science, 2009
The transport properties of high free volume glassy polymers such as poly(1-trimethylsilyl-1-propyne) (PTMSP) were analyzed by comparing the steady-state permeation behavior with the transient diffusion of light hydrocarbons. It has been observed that the apparent diffusivity measured in the two different modes are indeed quite different from one another, even by nearly an order of magnitude. The behavior can be explained by considering the high free volume glassy polymer as a two-phase system formed by a continuous solid phase and a discontinuous nano-void phase, with a suitable degree of interconnection. The influence of pore distribution and pore connectivity on the differences observed between transient sorption and steady permeation behavior has been analyzed by performing various mathematical simulations of transient and steady-state diffusion for different morphological structures of the two-phase system, used to model the polymer matrix. Qualitative comparison indicates that the difference experimentally observed is associated to a pore interconnectivity effect and to the corresponding anisotropy in pore distribution.
Elementary prediction of gas permeability in glassy polymers
The transport model proposed by Minelli and Sarti for the representation of gas and vapor permeability in glassy polymers has been extensively applied to various systems, and the model results are thoroughly analyzed. The approach is based on fundamental theory for the diffusion of low penetrant species in polymers, in which the diffusivity is considered as the product of the molecular mobility, and a ther-modynamic coefficient, accounting for the concentration dependence of the chemical potential. The model relies on the thermodynamic description of the penetrant/polymer systems provided by the NonEquilibrium Thermodynamics for Glassy Polymers (NET-GP) approach. The penetrant mobility is assumed to depend exponentially on penetrant concentration, and the model contains two parameters only: mobility coefficient at infinite dilution and plasticization factor. The model parameters obtained from the analysis of the permeability behaviors of various systems have been examined and general correlations are derived. The mobility coefficient is indeed correlated to the properties of the pure penetrants (penetrant molecular size) and pure polymer (fractional free volume and characteristic energy). This allows the derivation of a simple and general expression for the prediction of the permeability of any penetrant species in glassy polymers in the range of low penetrant pressures, as well as the selectivity of any gas pair. Remarkably, the model predictions are able to represent quite accurately the experimental data available in the literature. Furthermore, the plasticization factor is correlated to the swelling produced by the penetrant into the glassy polymer matrix, obtaining thus a reliable tool for the estimation of the pressure dependence of gas permeability on upstream pressure.