Measurement of submicrometric intrinsic spatial resolution for active pixel sensors (original) (raw)
Related papers
Space resolution of a silicon pixel detector as a function of the track angle
Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 1997
We measured the spatial resolution of a 300 urn thick 75 x 500 urn silicon pixel detector as a function of the track angle using a 120 GeV pion beam. We observed that 13% of tracks perpendicular to the detector give a signal on two neighboring pixels; this fraction increases to 50% at an angle of 15" w.r.t. the normal incidence direction. The average spatial resolution is 28.2 urn at 0" and 14.6 urn at 15". The detector efficiency is not affected by the charge sharing between pixels. Our data agree with the predictions of a simple geometrical model describing the charge sharing in the region between pixels. This model can be the basis for a full simulation of the behaviour of a pixel detector.
Limits in point to point resolution of MOS (Metal-Oxide-Semiconductor) based pixels detector arrays
2018
In high energy physics point to point resolution is a key prerequisite for particle detector pixel arrays. Current and future experiments require the development of inner-detectors able to resolve the tracks of particles down to the micron range. Present-day technologies, although not fully implemented in actual detectors can reach a 5 micometer limit, based on statistical measurements, with a pixel-pitch in the 10 micrometer range. Attempts to design small pixels based on SOI (Silicon On Insulator) technology will be briefly recalled here. This paper is devoted to the evaluation of the building blocks with regard to their use in pixel arrays for the accurate tracking of the charged particles. We will make here a simulations based quantitative evaluation of the physical limits in the pixel size. A design based on CMOS (Complementary Metal-Oxide-Semiconductor) compatible technologies that allows a reduction of the pixel size down to the sub-micronmeter range is introduced. Its physic...
A grazing angle technique to measure the charge collection efficiency for CMOS active pixel sensors
Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2011
Recently, CMOS Monolithic Active Pixels Sensors have become strong candidates as pixel detectors to be used in high energy physics experiments. A very good spatial resolution and an excellent detection efficiency could be obtained with these detectors. Beside spatial resolution and detection efficiency, an important parameter to be investigated is the charge collection efficiency (CCE) as a function of the distance from the detector surface. In this paper a new approach to measure the CCE profile by means of ionizing particles is proposed.
Limits in point to point resolution of MOS based pixels detector arrays
2017
In high energy physics point-to-point resolution is a key prerequisite for particle detector pixel arrays. Current and future experiments require the development of inner-detectors able to resolve the tracks of particles down to the micron range. Present-day technologies, although not fully implemented in actual detectors, can reach a 5-μm limit, this limit being based on statistical measurements, with a pixel-pitch in the 10 μm range. This paper is devoted to the evaluation of the building blocks for use in pixel arrays enabling accurate tracking of charged particles. Basing us on simulations we will make here a quantitative evaluation of the physical and technological limits in pixel size. Attempts to design small pixels based on SOI technology will be briefly recalled here. A design based on CMOS compatible technologies that allow a reduction of the pixel size below the micrometer is introduced here. Its physical principle relies on a buried carrier-localizing collecting gate. Th...
Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2001
A novel Monolithic Active Pixel Sensor (MAPS) for charged particle tracking made in a standard CMOS technology is proposed. The sensor is a photodiode, which is readily available in a CMOS technology. The diode has a special structure, which allows the high detection e$ciency required for tracking applications. The partially depleted thin epitaxial silicon layer is used as a sensitive detector volume. Semiconductor device simulation, using either ToSCA based or 3-D ISE-TCAD software packages shows that the charge collection is e$cient, reasonably fast (order of 100 ns), and the charge spreading limited to a few pixels only. A "rst prototype has been designed, fabricated and tested. It is made of four arrays each containing 64;64 pixels, with a readout pitch of 20 m in both directions. The device is fabricated using standard submicron 0.6 m CMOS process, which features twin-tub implanted in a p-type epitaxial layer, a characteristic common to many modern CMOS VLSI processes. Extensive tests made with soft X-ray source (Fe) and minimum ionising particles (15 GeV/c pions) fully demonstrate the predicted performances, with the individual pixel noise (ENC) below 20 electrons and the Signal-to-Noise ratio for both 5.9 keV X-rays and Minimum Ionising Particles (MIP) of the order of 30. This novel device opens new perspectives in high-precision vertex detectors in Particle Physics experiments, as well as in other application, like low-energy beta particle imaging, visible light single photon imaging (using the Hybrid Photon Detector approach) and high-precision slow neutron imaging.
Characterisation of a pixel sensor in 0.20 μ m SOI technology for charged particle tracking
Nuclear Instruments & Methods in Physics Research Section A-accelerators Spectrometers Detectors and Associated Equipment, 2011
This paper presents the results of the characterisation of a pixel sensor manufactured in 0:2 mm SOI technology integrated on a high-resistivity substrate, and featuring several pixel cell layouts for charge collection optimisation. The sensor is tested with short IR laser pulses, X-rays and 200 GeV pions. We report results on charge collection, particle detection efficiency and single point resolution.
A Novel 2-D Position Sensitive Silicon Detector With Micron Resolution for Heavy Ion Tracking
IEEE Transactions on Nuclear Science, 2006
A new 2D position sensitive silicon detector for tracking of energetic heavy ions is under development in a program to study the radiation effect within a single human cell. The detector is based on a concept of interleaved pixel electrodes arranged in a projective 2D strip readout (stripixel). A fine position resolution in the sub-micron range can be achieved by determining the centroid of the charge collected on pixel electrodes with a granularity in the range of 10µm. Beam test results with 1GeV/n Fe ions have demonstrated an rms position resolution of about 0.5µm with a 30µm pixel pitch.
Optimization of Tracking Performance of CMOS Monolithic Active Pixel Sensors
IEEE Transactions on Nuclear Science, 2007
CMOS Monolithic Active Pixel Sensors (MAPS) provide an attractive solution for high precision tracking of minimum ionizing particles. In these devices, a thin, moderately doped, undepleted silicon layer is used as the active detector volume with the readout electronics implemented on top of it. Recently, a new MAPS prototype was fabricated using the AMS 0.35 m OPTO process, featuring a thick epitaxial layer. A systematic study of tracking performance of that prototype using high-energy particle beam is presented in this work. Noise performance, signal amplitude from minimum ionizing particles, detection efficiency, spurious hit suppression and spatial resolution are shown as a function of the readout pitch and the charge collecting diode size. A test array with a novel readout circuitry was also fabricated and tested. Each pixel circuit consists of a front-end voltage amplifier, capacitively coupled to the charge collecting diode, followed by two analog memory cells. This architecture implements an on-pixel correlated double sampling method, allowing for optimization of integration independently of full frame readout time and strongly reduces the pixel-to-pixel output signal dispersion. First measurements using this structure are also presented.
Simulation of heavily irradiated silicon pixel sensors and comparison with test beam measurements
IEEE Transactions on Nuclear Science, 2000
We show that doubly peaked electric fields are necessary to describe grazing-angle charge collection measurements of irradiated silicon pixel sensors. A model of irradiated silicon based upon two defect levels with opposite charge states and the trapping of charge carriers can be tuned to produce a good description of the measured charge collection profiles in the fluence range from 0.5×10 14 neq/cm 2 to 5.9×10 14 neq/cm 2 . The model correctly predicts the variation in the profiles as the temperature is changed from −10 • C to −25 • C. The measured charge collection profiles are inconsistent with the linearly-varying electric fields predicted by the usual description based upon a uniform effective doping density. This observation calls into question the practice of using effective doping densities to characterize irradiated silicon. The model is now being used to calibrate pixel hit reconstruction algorithms for CMS.