Back-action of a driven nonlinear resonator on a superconducting qubit (original) (raw)

Superconducting qubit as a probe of quantum fluctuations in a nonlinear resonator

We measure the quantum fluctuations of a pumped nonlinear resonator using a superconducting artificial atom as an in situ probe. The qubit excitation spectrum gives access to the frequency and amount of excitation of the intracavity field fluctuations, from which we infer its effective temperature. These quantities are found to be in agreement with theoretical predictions; in particular, we experimentally observe the phenomenon of quantum heating.

Quantum heating of a nonlinear resonator probed by a superconducting qubit

2013

We measure the quantum fluctuations of a pumped nonlinear resonator using a superconducting artificial atom as an in situ probe. The qubit excitation spectrum gives access to the frequency and amount of excitation of the intracavity field fluctuations, from which we infer its effective temperature. These quantities are found to be in agreement with theoretical predictions; in particular, we experimentally observe the phenomenon of quantum heating.

High-Contrast Dispersive Readout of a Superconducting Flux Qubit Using a Nonlinear Resonator

Physical Review Letters, 2006

We demonstrate high-contrast state detection of a superconducting flux qubit. Detection is realized by probing the microwave transmission of a nonlinear resonator, based on a SQUID. Depending on the driving strength of the resonator, the detector can be operated in the monostable or the bistable mode. The bistable operation combines high-sensitivity with intrinsic latching. The measured contrast of Rabi oscillations is as high as 87 %; of the missing 13 %, only 3 % is unaccounted for. Experiments involving two consecutive detection pulses are consistent with preparation of the qubit state by the first measurement.

Measurement-Induced State Transitions in a Superconducting Qubit: Beyond the Rotating Wave Approximation

Physical Review Letters, 2016

Many superconducting qubit systems use the dispersive interaction between the qubit and a coupled harmonic resonator to perform quantum state measurement. Previous works have found that such measurements can induce state transitions in the qubit if the number of photons in the resonator is too high. We investigate these transitions and find that they can push the qubit out of the two-level subspace, and that they show resonant behavior as a function of photon number. We develop a theory for these observations based on level crossings within the Jaynes-Cummings ladder, with transitions mediated by terms in the Hamiltonian that are typically ignored by the rotating wave approximation. We find that the most important of these terms comes from an unexpected broken symmetry in the qubit potential. We confirm the theory by measuring the photon occupation of the resonator when transitions occur while varying the detuning between the qubit and resonator.

Quantum state sensitivity of an autoresonant superconducting circuit

Physical Review B, 2012

When a frequency chirped excitation is applied to a classical high-Q nonlinear oscillator, its motion becomes dynamically synchronized to the drive and large oscillation amplitude is observed, provided the drive strength exceeds the critical threshold for autoresonance. We demonstrate that when such an oscillator is strongly coupled to a quantized superconducting qubit, both the effective nonlinearity and the threshold become a non-trivial function of the qubit-oscillator detuning. Moreover, the autoresonant threshold is sensitive to the quantum state of the qubit and may be used to realize a high fidelity, latching readout whose speed is not limited by the oscillator Q.

ac Stark Shift and Dephasing of a Superconducting Qubit Strongly Coupled to a Cavity Field

Physical Review Letters, 2005

We have spectroscopically measured the energy level separation of a superconducting charge qubit coupled non-resonantly to a single mode of the electromagnetic field of a superconducting on-chip resonator. The strong coupling leads to large shifts in the energy levels of both the qubit and the resonator in this circuit quantum electrodynamics system. The dispersive shift of the resonator frequency is used to non-destructively determine the qubit state and to map out the dependence of its energy levels on the bias parameters. The measurement induces an ac-Stark shift of 0.6 MHz per photon in the qubit level separation. Fluctuations in the photon number (shot noise) induce level fluctuations in the qubit leading to dephasing which is the characteristic back-action of the measurement. A cross-over from lorentzian to gaussian line shape with increasing measurement power is observed and theoretically explained. For weak measurement a long intrinsic dephasing time of T2 > 200 ns of the qubit is found.

Two-resonator circuit quantum electrodynamics: Dissipative theory

Physical Review B, 2010

We present a theoretical treatment for the dissipative two-resonator circuit quantum electrodynamics setup referred to as quantum switch. There, switchable coupling between two superconducting resonators is mediated by a superconducting qubit operating in the dispersive regime, where the qubit transition frequency is far detuned from those of the resonators. We derive an effective Hamiltonian for the quantum switch beyond the rotating wave approximation and provide a detailed study of the dissipative dynamics. As a central finding, we derive analytically how the qubit affects the quantum switch even if the qubit has no dynamics, and we estimate the strength of this influence. The analytical results are corroborated by numerical calculations, where coherent oscillations between the resonators, the decay of coherent and Fock states, and the decay of resonator-resonator entanglement are studied. Finally, we suggest an experimental protocol for extracting the damping constants of qubit and resonators by measuring the quadratures of the resonator fields.

Dephasing of a Superconducting Qubit Induced by Photon Noise

Physical Review Letters, 2005

We have studied the dephasing of a superconducting flux-qubit coupled to a DC-SQUID based oscillator. By varying the bias conditions of both circuits we were able to tune their effective coupling strength. This allowed us to measure the effect of such a controllable and well-characterized environment on the qubit coherence. We can quantitatively account for our data with a simple model in which thermal fluctuations of the photon number in the oscillator are the limiting factor. In particular, we observe a strong reduction of the dephasing rate whenever the coupling is tuned to zero. At the optimal point we find a large spin-echo decay time of 4µs.

Dynamics of a superconducting qubit coupled to the quantized cavity field: a unitary transformation approach

The European Physical Journal D, 2014

We present a novel approach for studying the dynamics of a superconducting qubit in a cavity. We succeed in linearizing the Hamiltonian through the application of an appropriate unitary transformation followed by a rotating wave approximation (RWA). For certain values of the parameters involved, we show that it is possible to obtain a a Jaynes-Cummings type Hamiltonian. As an example, we show the existence of super-revivals for the qubit inversion.

Dynamics of dispersive single-qubit readout in circuit quantum electrodynamics

Physical Review A, 2009

The quantum state of a superconducting qubit nonresonantly coupled to a transmission line resonator can be determined by measuring the quadrature amplitudes of an electromagnetic field transmitted through the resonator. We present experiments in which we analyze in detail the dynamics of the transmitted field as a function of the measurement frequency for both weak continuous and pulsed measurements. We find excellent agreement between our data and calculations based on a set of Bloch-type differential equations for the cavity field derived from the dispersive Jaynes-Cummings Hamiltonian including dissipation. We show that the measured system response can be used to construct a measurement operator from which the qubit population can be inferred accurately. Such a measurement operator can be used in tomographic methods to reconstruct single and multiqubit states in ensemble-averaged measurements.