Relationship between tissue stiffness and degree of mineralization of developing trabecular bone (original) (raw)
Related papers
Intratrabecular distribution of tissue stiffness and mineralization in developing trabecular bone
Bone, 2007
The purpose of this study was to investigate the relation between bone tissue stiffness and degree of mineralization distribution and to examine possible changes during prenatal development. Understanding this may provide insight into adaptation processes and into deformation mechanisms of the bone microstructure. Mandibular condyles from four fetal and newborn pigs were used. Tissue stiffness was measured using nanoindentation, the degree of mineralization with microCT. Eight indents were made over the trabecular width of 15 trabeculae in each specimen, leading to a total of 960 indents. Subsequently, the degree of mineralization of these locations was determined. Intratrabecular variations in bone tissue stiffness and degree of mineralization showed a similar pattern; low at trabecular surfaces and higher in the cores. A strong correlation was found between the two variables, which remained unchanged during development. It was concluded that bone tissue in fetal and newborn trabecular cores resembles adult trabecular bone tissue properties and is distributed in a regular radial pattern in trabeculae. For the first time, it was shown that the intratrabecular tissue stiffness develops along the same path as the degree of mineralization. Knowledge regarding intratrabecular tissue stiffness and mineralization results in a better understanding of trabecular bone mechanical behavior on a structural and tissue level.
Annals of Biomedical Engineering, 2007
The load-transfer pathway in trabecular bone is largely determined by its architecture. However, the influence of variations in mineralization is not known. The goal of this study was to examine the influence of inhomogeneously distributed degrees of mineralization (DMB) on intratrabecular stresses and strains. Cubic mandibular condylar bone specimens from fetal and newborn pigs were used. Finite element models were constructed, in which the element tissue moduli were scaled to the local DMB. Disregarding the observed distribution of mineralization was associated with an overestimation of average equivalent strain and underestimation of von Mises equivalent stress. From the surface of trabecular elements towards their core the strain decreased irrespective of tissue stiffness distribution. This indicates that the trabecular elements were bent during the compression experiment. Inhomogeneously distributed tissue stiffness resulted in a low stress at the surface that increased towards the core. In contrast, disregarding this tissue stiffness distribution resulted in high stress at the surface which decreased towards the core. It was concluded that the increased DMB, together with concurring alterations in architecture, during development leads to a structure which is able to resist increasing loads without an increase in average deformation, which may lead to damage.
Interrelationship of trabecular mechanical and microstructural properties in sheep trabecular bone
Journal of Biomechanics, 2005
The ability to evaluate fracture risk at an early time point is essential for improved prognostics as well as enhanced treatment in cases of bone loss such as from osteoporosis. Improving the diagnostic ability is inherent upon both high-resolution non-invasive imaging, and a thorough understanding of how the derived indices of structure and density relate to its true mechanical behavior. Using sheep femoral trabecular bone with a range of strength, the interrelationship of mechanical and microstructural parameters was analyzed using multi-directional mechanical testing and micro-computed tomography. Forty-five cubic trabecular bone samples were harvested from 23 adult female sheep, some of whom had received hind-limb vibratory stimuli over the course of 2 years with consequently enhanced mechanical properties. These samples were pooled into a low, medium, or high strength group for further analysis.
Properties of growing trabecular ovine bone
The journal of bone and joint surgery, 2000
W e aimed to highlight the relationship between age and the architectural properties of trabecular bone, to outline the patterns in which the variations in these properties take place, and to investigate the influence of the architecture on the mechanical properties of trabecular bone in growing animals. We studied 30 lambs in three age groups and 20 sheep in two age groups. Cubes of subchondral bone were cut from the proximal tibia according to a standardised protocol. They were serially sectioned and their architectural properties were determined. Similar cubes were obtained from the identical anatomical position of the contralateral tibia and their compressive mechanical properties measured. The values obtained from the skeletally immature and mature individuals were compared. Multiple regression analyses were performed between the architectural and the mechanical properties. The bone volume fraction, the mean trabecular volume, the architectural and the mechanical anisotropy, the elastic modulus, the bone strength, the energy absorption to failure, and the elastic energy correlated positively with increasing age whereas the connectivity density, the bone surface density, the ultimate strain, the absorption of viscoelastic energy and the relative loss of energy correlated inversely. The values of all variables were significantly different in the skeletally mature and immature groups. We determined the patterns in which the variations took place. The bone volume fraction of the trabecular bone tissue was found to be the major predictor of its compressive mechanical properties. Together with the mean trabecular volume and the bone surface density, it explained 81% of the variations in the compressive elastic modulus of specimens obtained from the contralateral tibiae.
Microarchitectural and Physical Changes During Fetal Growth in Human Vertebral Bone
Journal of Bone and Mineral Research, 2003
The ossification process in human vertebra during the early stage of its formation was studied by X-ray diffraction (XRD) and X-ray microtomography (CT) at the European Synchrotron Radiation Facility (ESRF), Grenoble, France. Twenty-two samples taken from vertebral ossification centers of human fetal bone (gestational age ranging between 16 and 26 weeks) were investigated. The analysis of three-dimensional images at high spatial resolution (ϳ10 and ϳ2 m) allows a detailed quantitative description of bone microarchitecture. A denser trabecular network was found in fetal bone compared with that of adult bone. The images evidenced a global isotropic structure clearly composed of two regions: a central region (trabecular bone) and a peripheral region (immature bone). XRD experiments evidenced hydroxyapatite-like crystalline structure in the mineral phase at any fetal age after 16 weeks. Interestingly, the analysis of XRD patterns highlighted the evolution of crystalline structure of mineralized bone as a function of age involving the growth of the hydroxyapatite crystallites. (J Bone Miner Res 2003;18:760 -768)
The mechanical consequences of mineralization in embryonic bone
Bone, 2004
The purpose of this study was to examine the effect of mineralization on the mechanical properties of embryonic bone rudiments. For this purpose, four-point bending experiments were performed on unmineralized and mineralized embryonic mouse ribs at 16 and 17 days of gestational age. Young's modulus was calculated using force -displacement data from the experiment in combination with finite element analysis (FEA). For the unmineralized specimens, a calculated average for the Young's modulus of 1.11 ( F 0.62) MPa was established after corrections for sticking to the four-point bending device and aspect ratio, which is the ratio between the length of the bone and its diameter. For the mineralized specimens, the value was 117 ( F 62) MPa after corrections. Hence, Young's moduli of embryonic bone rudiments increase by two orders of magnitude within 1 day, during endochondral ossification. As an effect, the hypertrophic chondrocytes in the calcifying cartilage experience a significant change in their mechanical environment. The chondrocytes are effectively stress shielded, which means that they do not carry stresses since stresses are supported by the stiffest parts of the tissue, which are in this case the diaphyseal cortex and the calcified matrix. The deformability of the hypertrophic chondrocytes is, therefore, severely reduced. Since the transition is so sudden and enormous, it can be seen as a process of 'catastrophic' proportion for the hypertrophic chondrocytes. The subsequent resorption of calcified cartilage and the expansion of the marrow cavity could be consequential to stress shielding. D 2004 Elsevier Inc. All rights reserved.
Properties of growing trabecular ovine bone: Part I
The Journal of Bone and Joint Surgery, 2000
O ur aim was to determine the relationship between age and the mechanical and physical properties of trabecular bone, to describe the patterns in which the variations in these properties take place, and to investigate the influence of the physical properties on the mechanical characteristics of trabecular bone during growth. We used 30 lambs in three age groups and 20 sheep in two age groups. Cubes of subchondral bone were cut from the proximal tibia according to a standardised protocol. We performed non-destructive compression tests of the specimens in three orthogonal directions and compression tests to failure in the axial direction. The physical properties of the specimens were also determined. The data were correlated with age and compared in skeletally immature and mature animals. Multiple regression analyses were performed between the mechanical and the physical properties. Age correlated positively with elastic modulus, bone strength, energy absorption to failure, elastic energy, mechanical anisotropy ratio, tissue density, apparent density, apparent ash density, and bone mineral content, and inversely with ultimate strain, viscoelastic energy absorption, relative energy loss, the collagen content of bone and the percentage porosity. The values of all variables were significantly different in the skeletally mature and immature groups. The apparent density of trabecular bone tissue was found to be the major predictor of its compressive mechanical properties. Together with the content of bone muscle and bone collagen, the apparent density could explain 84% of the variation in the elastic modulus, whereas only a small portion of the variation in ultimate strain could be explained by the variation in apparent density.
Regional differences in architecture and mineralization of developing mandibular bone
The anatomical record. Part A, Discoveries in molecular, cellular, and evolutionary biology, 2006
The goal of this study was to investigate the mutual relationship between architecture and mineralization during early development of the pig mandible. These factors are considered to define the balance between the requirements for bone growth on the one hand and for load bearing on the other. Architecture and mineralization were examined using micro-CT, whereas the mineral composition was assessed spectrophotometrically in groups of fetal and newborn pigs. The development of the condyle coincided with a reorganization of bone elements without an increase in bone volume fraction, but with an increase in mineralization and a change in mineral composition. In the corpus, the bone volume fraction and mineralization increased simultaneously with a restructuring of the bone elements and a change in mineral composition. The growth of the condyle was reflected by regional differences in architecture and mineralization. The anterior and inferior regions were characterized by a more dense bo...
Journal of Biomechanics, 2007
The purpose of the present study was to examine the changes in apparent mechanical properties of trabecular bone in the mandibular condyle during fetal development and to investigate the contributions of altering architecture, and degree and distribution of mineralization to this change. Three-dimensional, high-resolution micro-computed tomography (microCT) reconstructions were utilized to assess the altering architecture and mineralization during development. From the reconstructions, inhomogeneous finite element models were constructed, in which the tissue moduli were scaled to the local degree of mineralization of bone (DMB). In addition, homogeneous models were devised to study the separate influence of architectural and DMB changes on apparent mechanical properties. It was found that the bone structure became stiffer with age. Both the mechanical and structural anisotropies pointed to a rod-like structure that was predominantly oriented from anteroinferior to posterosuperior. Resistance against shear, also increasing with age, was highest in the sagittal plane. The reorganization of trabecular elements, which occurred without a change in bone volume fraction, contributed to the increase in apparent stiffness. The increase in DMB, however, contributed more dominantly. Incorporating the observed inhomogeneous distribution of mineralization decreased the apparent stiffness, but increased the mechanical anisotropy. This denotes that there might be a directional dependency of the DMB of trabecular elements, i.e. differently orientated trabecular elements might have different DMBs. In conclusion, the changes in DMB and its distribution are important to consider when studying mechanical properties during development and should be considered in other situations where differences in DMB are expected. r