Mediciones de propagación de ondas de radio en banda ancha en interiores para 5.4 Ghz (original) (raw)
Related papers
Wideband Indoor Radio Propagation Measurements at 5.4 GHz
2012
Wideband indoor time domain measurements at 5.4 GHz are presented in this paper. A swept Time Delay Cross Correlator is used to measure the radio channel, and the measurements are performed using an autonomous robot that follows a predefi ned route line-of-sight and non-line-of-sight modern offi ce buildings. Analysis shows that the RMS delay spread follows a normal distribution whose mean does not always increase with distance. Also, the global statistics of the RMS delay spread follow a truncated normal distribution with a bett er fi t. Results are presented in the form of RMS delay spread and power delay profi les.
RMS delay and coherence bandwidth measurements in indoor radio channels in the UHF band
IEEE Transactions on Vehicular Technology, 2001
A study of time dispersion in different indoor line-ofsight radio channels in the 492-862 MHz band is presented in this paper. A combined method to filter the noise in the measured impulse response is described. The effect of frequency windowing on the impulse responses and the root mean square (rms) delay spread is also investigated. It has been found that, in general, the use of windows with lower side-lobe levels yields larger values of the rms delay spread. The relation between the mean delay and the rms delay spread has also been studied for copolar and crosspolar channels. The dependence of the coherence bandwidth on the rms delay spread has been considered, and an inverse relation has been tested for both components.
RMS Delay Spread vs. Coherence Bandwidth from 5G Indoor Radio Channel Measurements at 3.5 GHz Band
Sensors
Our society has become fully submersed in fourth generation (4G) technologies, setting constant connectivity as the norm. Together with self-driving cars, augmented reality, and upcoming technologies, the new generation of Internet of Things (IoT) devices is pushing the development of fifth generation (5G) communication systems. In 5G architecture, increased capacity, improved data rate, and decreased latency are the objectives. In this paper, a measurement campaign is proposed; we focused on studying the propagation properties of microwaves at a center frequency of 3.5 GHz, commonly used in 5G cellular networks. Wideband measurement data were gathered at various indoor environments with different dimensions and characteristics. A ray-tracing analysis showed that the power spectrum is dominated by the line of sight component together with reflections on two sidewalls, indicating the practical applicability of our results. Two wideband parameters, root mean square delay spread and co...
Distance Dependent Model for the Delay Power Spectrum of In-room Radio Channels
A model based on experimental observations of the delay power spectrum in closed rooms is proposed. The model includes the distance between the transmitter and the receiver as a parameter which makes it suitable for range based radio localization. The experimental observations motivate the proposed model of the delay power spectrum with a primary (early) component and a reverberant component (tail). The primary component is modeled as a Dirac delta function weighted according to an inverse distance power law (d −n). The reverberant component is an exponentially decaying function with onset equal to the propagation time between transmitter and receiver. Its power decays exponentially with distance. The proposed model allows for the prediction of e.g. the path loss, mean delay, root mean squared (rms) delay spread, and kurtosis versus the distance. The model predictions are validated by measurements: they show good agreement with respect to distance dependent trends.
Joint Modeling of Received Power, Mean Delay, and Delay Spread for Wideband Radio Channels
IEEE Transactions on Antennas and Propagation
We propose a multivariate log-normal distribution to jointly model received power, mean delay, and root mean square (rms) delay spread of wideband radio channels, referred to as the standardized temporal moments. The model is validated using experimental data collected from five different measurement campaigns (four indoor scenarios and one outdoor scenario). We observe that the received power, the mean delay, and the rms delay spread are correlated random variables, and therefore, should be simulated jointly. Joint models are able to capture the structure of the underlying process, unlike the independent models considered in the literature. The proposed model of the multivariate log-normal distribution is found to be a good fit for a large number of wideband data sets.
On estimating the RMS delay spread from the frequency-domain level crossing rate
IEEE Communications Letters, 2000
It is shown that the level crossing rate (LCR) of a Rayleigh distributed stochastic process is proportional to the second centralized moment of the normalized power spectrum of the underlying complex Gaussian process. This proportionality factor is independent of the power spectrum. The relation can be applied for estimating the rms delay spread of time-dispersive (= frequency-selective) radio channels from swept-frequency power measurements, where the rms delay spread is proportional to the LCR in the frequency-domain, independent of the channel impulse response.
Measurement, 2016
The statistical analysis of the RMS delay spread is achieved based on the results obtained from an outdoor time-varying ultra-wideband (UWB) channel measurement. The paper reports on the RMS delay spread values, the cumulative distribution functions (CDFs) and the probability density functions (PDFs) for the measured channel configurations with their estimated parameters. Findings show how the RMS delay spread values are fluctuating for different channel configurations within the same measurement campaign. For example, 35 ns and 2.5 ns have been obtained for different channels. The differences in the measured instantaneous RMS delay spread leads to obtaining different PDFs that fit the measured data where Generalized Pareto distribution is dominant. The relation between the RMS delay spread and the channel path loss has been studied. Positive correlation is seen for all measured channels with different amounts. The highest correlation value is 0.7675 while the lowest is 0.2951. The coherence bandwidth analysis is also conducted, and the values are fluctuating as the case of the RMS delay spread. The obtained values varies between 325.3 MHz and 5.7 MHz.
Propagation measurements at 5.2 GHz in commercial and domestic environments
1997
This paper presents the results of an investigation into the wideband propagation characteristics of four different indoor operational environments within the 5.2 GHz band using a swept time-delay cross-correlator (STDCC) channel sounder. For each environment the cumulative distribution of delay spread for both omni directional and a 20 dB horn antenna are presented. It is shown that a suitably aligned narrowbeam antenna makes possible to achieve delay spread reduction through spatial filtering. The effects of moving people and different room transmission situations are also presented.
Propagation measurements of a 3.5 GHz signal: path-loss and variability studies
Microwave and Optoelectronics SBMO/IEEE MTT-S International Conference, 2001
The results of propagation measurements of a 3.5 GHz signal realized on a typical urban environment at Rio de Janeiro city are presented. The path-loss, obtained from two different urban environments, is calculated and compared with the most popular prediction models in the literature. Variability characteristics such as the large-scale fading and small scale fading of the envelope of a