Interface Shear Strength of Geosynthetic Clay Liner (GCL) and Residual Soil (original) (raw)
Related papers
Effect of Shear Displacement Rate on Internal Shear Strength of a Reinforced Geosynthetic Clay Liner
Geosynthetics International
Torsional ring shear tests were performed to evaluate the effect of shear displacement rate on the internal shear strength of a needle-punched geosynthetic clay liner (GCL) under different normal stresses. The test results suggest that the internal shear strength of the needle-punched GCL depends on the following three factors: (i) resistance against reinforcement fibers pulling out and/or tearing; (ii) amount of positive pore-water pressure induced during shear; and (iii) bentonite water content at the time of shearing. The laboratory tests indicate that the net effect of these three factors result in the peak internal shear strength being less sensitive to shear displacement rate at normal stresses between 200 and 400 kPa than at normal stresses less than 200 kPa. Shear displacement rate appears to have little influence on the residual internal shear strength regardless of normal stress. The amount of shear displacement required to reach the peak and residual internal shear streng...
Evaluation on the Use of Alternative Materials in Geosynthetic Clay Liners
Soils and Rocks
Geosynthetic clay liners (GCL) have been increasingly used in barrier systems of waste disposal areas and in hydraulic works. However, sometimes they are discarded as possible barrier solutions in these works because of their greater costs in comparison with other solutions (geomembranes or compacted clay liners). This paper presents a laboratory study to investigate the technical feasibility of mixing alternative materials to bentonite for the production of alternative low cost GCLs. The alternative materials used were sand, clay and tire grains. Direct shear, consolidation, and expansibility tests were carried out on bentonite mixtures with varying percentages in mass of the alternative material. Ramp tests and expansibility tests were also performed on alternative GCLs manufactured with these types of mixtures. The results obtained showed that the presence of the alternative materials in the bentonite increased the shear strength and the permittivity of the mixture and reduced it...
MATEC Web of Conferences, 2018
This research focuses on the interface shear performance between geotextile and soil with various percentages of bentonite and sodium bentonite for landfill stability by using Direct Shear Test. Admixtures are mixed with clay to improve its performance as a liner material due to their ability to fill the voids between soil particles and also the most effective sealants. The aim of this study is focused on evaluating the effectiveness of bentonite and sodium bentonite on improving interface shear strength of fine soil. In this study, direct shear box was used to measure the interface shear strength of soil with different percentages of bentonite and sodium bentonite at optimum moisture content. Analysis shows that the most suitable percentage is of 5 % of bentonite and 2.5 % of sodium bentonite due to the highest interface shear strength of the mixture with geosynthetic. It is clearly shown that 2.5 % sodium bentonite is the most suitable percentage to be used as admixture for landfill stability as it gives higher interface shear strength.
Shear Behavior of Reinforced Geosynthetic Clay Liners
Ring shear tests were performed to evaluate the effect of bentonite on theinterfaceshearstrengthbetweenageomembraneandareinforcedgeosyntheticclay liner (GCL), and the internal shear behavior of reinforced GCLs. The tests yielded an interfaceshearstrengththatisinagreementwiththeback-calculatedshearstrengthval- ues from two test pads that deformed at the U.S. Environmental Protection Agency GCL Test SectioninCincinnati, Ohio, USA. The ring sheartests showedthat the inter- nal shear strength of reinforced GCLs depends on the following two factors: (i) resist- ance againstreinforcing fiberpull-out and/ortearing; and,(ii) shearstrength ofbenton- ite. The laboratory tests indicate that fiber resistance is the predominant internal shear strengthfactor.Recommendationsarepresentedfortherateofshearthatshouldbeused for internal shear testing of reinforced GCLs.
Effect of Specimen Conditioning on Geosynthetic Clay Liner Shear Strength
Specifications for laboratory shear strength testing of geosynthetic clay liners (GCLs) must replicate field conditions while still accounting for time and cost considerations. A database of 414 GCL in- ternal and 534 GCL-geomembrane (GM) interface shear strength results has been assembled. Specifically, the results of large-scale direct shear tests conducted by a single independent laboratory are evaluated to de- velop guidelines on specimen conditioning. It was found that both the GCL internal and interface peak shear strengths decreased with increasing time of hydration (th). However, the GCL internal shear strength did not change for th beyond 48 hs and the GCL-GM interface shear strength did not change for th beyond 24 hs. The normal stress used during hydration affected significantly the peak shear strength due to bentonite swelling. Hydration under low normal stress followed by consolidation led to similar GCL internal peak shear strength as hydration under high normal stress...
Characterization of Water Retention Property of Geosynthetic Clay Liner
2016
Geosynthetic clay liner (GCL) is used as hydraulic barrier in municipal solid waste landfill (MSWL) due to the very low hydraulic conductivity of bentonite component of GCL. The GCL is used in MSWL cover liner as an alternative to compacted clay liner. One of main function of the cover liner is to limit the infiltration of rainfall into the MSWL. GCL should be sufficiently hydrated before placement for the effective performance; however, the moisture content of GCL might vary due to the fluctuations in the temperature and rainfall within the landfill area. Hence, the efficiency of the GCL in terms of hydraulic conductivity under varied moisture content need to be established. The performance of GCL under varied moisture condition can be estimated from water retention curve (WRC) of GCL. WRC is a fundamental relationship between suction and its corresponding moisture content. In the present study, total suction of GCL at different moisture content is determined using dew point Potent...
Shear Behavior of an Unreinforced Geosynthetic Clay Liner
Geosynthetics International
Dry and hydrated specimens of an unreinforced geomembrane-backed geosynthetic clay liner (GCL) were sheared against a textured geomembrane using a torsional ring shear apparatus to study the shear behavior of geomembrane encapsulated bentonite. Shearing of the dry GCL against a textured geomembrane at high normal stresses resulted in failure occurring within the GCL adhesive that attaches the bentonite to the geomembrane backing and not the GCL bentonite/geomembrane interface. This type of failure occurred when both smooth and textured geomembranes were used as the GCL backing material. Conversely, shearing of the hydrated GCL against a textured geomembrane resulted in failure occurring at the GCL bentonite/textured geomembrane interface. The order of hydration and normal stress application was found to significantly affect the GCL/textured geomembrane interface shear strength. The mobilized shear strength of the GCL/textured geomembrane interface does not equal the drained shear st...
Geotechnical characterisation of clay admixed with quarry fines as potential liner material
Natural clay soil is commonly suited as a liner material for imparting impermeable layer and serves as a barrier against transportation of landfill leachate into the ground. This paper investigates the geotechnical characteristics of clay admixed with quarry fines that may be used as landfill liner material. The virgin clay and quarry fines used in this study were brought from a place Lalgudi in Trichy and SRC projects quarry site in Salem, respectively. The quarry fines were added to the clay at 5, 10, 15, 20 and 25% by dry weight of the clay. The tests conducted were specific gravity, atterberg limits, compaction behaviour. The liquid limit, plastic limit and plasticity index of clay was found to be 47.4%, 23.31% and 24.09 respectively. It is found out that the six clay liners composites, raw clay soil gave the highest optimum moisture content and smallest dry density, 25% of quarry fines amended with clay had the highest dry density 1.505 g/cm3 and a lowest optimum moisture content of 15.2%. Based on Atterberg limits and compaction characteristics, the clay admixed with quarry fines can be used suitably for liner material.