Emissions from Light-Duty Diesel and Gasoline in-use Vehicles Measured on Chassis Dynamometer Test Cycles (original) (raw)

Emissions of Euro 3-5 Passenger Cars Measured Over Different Driving Cycles

The reduction in vehicle exhaust emissions achieved in the last two decades is offset by the growth in traffic, as well as by changes in the composition of emitted pollutants. The present investigation illustrates the emissions of in-use gasoline and diesel passenger cars using the official European driving cycle and the ARTEMIS real-world driving cycle. It was observed that some of the vehicles do not comply with the corresponding regulations. Significant differences in emissions were observed between driving cycles. Not all pollutants showed a tendency to decrease from Euro 3 to Euro 5.

Emissions of New Technology Euro 4 Vehicles

2009

Pollutants emissions by on-road transport is still responsible for air pollution in urban areas due to the growing number of circulating vehicle. Despite of technological improvements in terms of engine and after treatment devices performance, exhausts of vehicles decisively influence the urban air quality. In recent years particular concern is given to organic micropollutants and particulate emissions, for their dangerous effects on humans and environmental health.

Determination of Exhaust Emission Levels from Vehicles Based on Fuel Use and Comparing Test Results to Euro -6 Regulations as a Benchmark

2022

The study investigated the emission of Hydrocarbons (HC), Oxides of Nitrogen (NOx), Carbon monoxide (CO) and Carbon dioxide (CO 2) in vehicles. The study adopted a multiple research design approach to select five cities, garages and vehicles for the study. Whilst the cities were purposefully selected, the garages or fitting shops were selected by first identifying a garage owner who then introduces the researcher to another garage. This approach continued until the 200 targeted vehicles were reached. Two hundred vehicles used for the study were randomly selected as owners of vehicles visited the fitting shops for regular maintenance of their vehicles. The data was analyzed using analysis of variance (ANOVA) to compare the emission of various gasses. The study revealed that diesel vehicles emissions at 34.1 km/hr were considerably reduced when compared with EURO-6. At this speed CO emission was 0.01 g/km and lower than the standard level of 0.50 g/km. Oxides of Nitrogen (NOx) emissions of 2.3g/km was higher than the EURO-6 standard of 0.08g/km. Hydrogen Carbons (HC) emission of 0.65g/km was higher than EURO-6 standard of 0.17g/km. It is recommended that advanced technologies with no or little gaseous emissions must be adopted by vehicular manufacturing nations to curb or reduce the emission of harmful gases that leads to global warming.

Assessment of Gaseous and Particulate Emissions of a Euro 6d-Temp Diesel Vehicle Driven >1300 km Including Six Diesel Particulate Filter Regenerations

Atmosphere

Diesel-fueled vehicles have classically had high particulate and NOx emissions. The introduction of Diesel Particulate Filters (DPFs) and Selective Catalytic Reduction for NOx (SCR) systems have decreased the Particle Number (PN) and NOx emissions, respectively, to very low levels. However, there are concerns regarding the emissions released during the periodic DPF regenerations, which are necessary to clean the filters. The absolute emission levels and the frequency of the regenerations determine the contribution of regenerations, but where they happen (city or highway) is also important due to different contributions to human exposure. In this study, we measured regulated and non-regulated emissions of a Euro 6d-temp vehicle both in the laboratory and on the road. PN and NOx emissions were similar in the laboratory and on-the road, ranging around 1010 p/km and 50 mg/km, respectively. Six regeneration events took place during the 1300 km driven, with an average distance between reg...

Comparison of exhaust emission from Euro 3 and Euro 6 motor vehicles fueled with petrol and LPG based on real driving conditions

Combustion Engines, 2019

Constantly increasing requirements regarding emission limits for harmful exhaust components force vehicle manufacturers to im-prove the construction of vehicle engines as well as exhaust gas cleaning systems. In addition to modifications in the field of technology of motor vehicles themselves, it is also important to study the impact of alternatives to petrol or diesel fuels. One of the most popular fossil fuel is liquid petroleum gas. In the paper, the results of comparative studies on the emission of harmful exhaust components of vehicles meeting the Euro 3 and Euro 6 standards in the field of petrol and LPG fuel use are presented. Emission measurement was performed using a portable emission measurement system from Horiba OBS-2200 under real traffic conditions. The presented results show the differences between the tested vehicles and the fuels used.