Laboratory Experiments on Mitigation against Charging and Arcing of Solar Array Paddle Backside of Polar Orbiting Satellites (original) (raw)
JOURNAL OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES
In case of a polar orbiting satellite, insulative surfaces located on the wake side of solar array paddle can be charged negatively by aurora electrons. We carried out laboratory experiments to evaluate risks of charging and arcing on thermal control film surfaces attached on a solar array paddle backside. We used two test coupons of different design. Both of them used the same materials of flight hardware as the Advanced Land Observing Satellite (ALOS) and the Optical Inter-orbit Communications Engineering Test Satellite (OICETS), which are domestic polar orbiting satellites. When the thermal control film surface was insulated and a silver layer was not connected to coupon ground, the film surface was charged to a negative value 1-2 kV lower than the electron beam energy. Many primary arcs and flashover were observed at the edge of silver layer and film surface, respectively. Some areas of silver layer were destroyed by primary arcs. On the other hand, the film with conductive coating connected to a substrate with resistance of 10 6-10 9 Ω suppressed surface charging and flashover on the film under the electron flux of 1 × 10 15-1.4 × 10 17 m −2 s −1 , effectively. We made a new coupon which had three features to give improved performance of arcing and charging mitigation. (1) Connecting the silver layer to the substrate by conductive adhesive to suppress charging and arcing at the edge of silver layer. (2) Film surface coating by conductive material and connected with conductive adhesive to avoid charging. (3) Hiding all the edges of silver layer by conductive adhesive. This coupon suppressed any arcing and charging on the film surface up to 20 keV electron beam irradiation.
Related papers
ESD Ground Test of Solar Array for a Wideband InterNetworking Satellite
JOURNAL OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES
An ESD (Electro-Static Discharge) test was carried out on solar array for Wideband InterNetworking engineering test and Demonstration Satellite (WINDS). An electron beam was used to simulate the inverted potential gradient conditions. The sustained arc was not observed for test coupons with Room Temperature Vulcanization (RTV) Si grouting at the inter-string gap and thicker RTV layer between cells and Kapton sheet. Arc pulses short-circuited the PN junction of triple-junction cells once the arcs occurred at the cell edges. Effects of exposing bus bars to space without RTV coating was also investigated. There was no detrimental effect associated with the exposed bus bars.
Threshold for Secondary Arc Formation on Solar Array in Low Earth Orbit Plasma Environment
JOURNAL OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES
Arcing on satellite solar array due to interaction with space plasma may cause permanent loss of satellite power, once the arc becomes permanent sustained arc. An arc on solar array becomes a secondary arc when solar array circuit is short-circuited and provides energy to the arc plasma. The permanent sustained arc, the final stage of the secondary arc, destroys a solar array string or the complete power circuits at the worst case. To investigate the threshold conditions for the secondary arc formation, laboratory tests are carried out in a xenon plasma chamber simulating LEO plasma environment with an external circuit simulating a spacecraft power system. Solar array coupon panels simulating the hot and return ends of a string circuit are tested for various combinations of string voltage and string current. Experimental results show that formation of secondary arc strongly depends on the string voltage and duration of secondary arc depends on the string current.
Ground Investigation of Sustained Arc Phenomena in Power Cables on ADEOS-II Satellite
JOURNAL OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES
We investigated the power loss due to the sustained arc between primary satellite power cables. If the multi layer insulation (MLI) film on a satellite is electrically floating, energetic electrons in space will charge this film. We carried out an internal pressure measurement of MLI and ESD test on cable with cracks and wrapped with this film. When the negative voltage on the MLI exceeded −1 kV, a trigger arc discharge occurred between the MLI and the cables. Subsequently, a secondary arc discharge occurred between the cables themselves. In the specific condition, this secondary arc caused sustained arc which burned out the cables. The heat caused by arc tracking between the hot and return cables made them burn out. If this phenomenon had occurred in space, the satellite would have suffered great damage.
JOURNAL OF THE JAPAN SOCIETY FOR AERONAUTICAL AND SPACE SCIENCES
A system to identify the position where arc discharges occurred on a solar array in vacuum has been developed. The system is composed of a video camera, an A/D converter, a personal computer (PC) and a computer program. Analog video image of the solar array from the video camera is converted to digital one by the AD converter. The digital video image is recorded directly on a hard disk drive connected to the PC during an experiment without dropping any video frames. After the experiment, a picture image is extracted in memory bank from the stored video image by the computer program and is compared with a first frame of the video image. The position of arcs is identified by means of repeating this comparison over all frames. The system is built at a low cost with commercial hardware and reduces the time required for analysis remarkably.
Planetary Exploration by Magneto Plasma Sail
2004
A magneto-plasma sail produces the propulsive force due to the interaction between the artificial magnetic field around a spacecraft inflated by the plasma and the solar wind erupted from the Sun. The inflation of the magnetic field by the plasma was proposed by a group of the University of Washington and the basic research has just started. This paper summarizes the characteristics of the magneto plasma sail by comparing with the other low-thrust propulsion systems, and investigates its potential application to near future planetary missions. Finally, an engineering satellite to demonstrate the magneto-plasma sail is proposed as a first step.
Assessment of Radiative Reentry Environment around MUSES-C Capsule
Journal of The Japan Society for Aeronautical and Space Sciences, 2003
Forebody and aftbody radiative heating rates of the MUSES-C asteroid sample return capsule have been assessed along the reentry trajectory from an engineering standpoint. Nonequilibrium hypersonic flows around the capsule with ablation of the thermal protection system involved were determined by CFD calculations, while the radiative heat transfer was computed by the radiation code SPRADIAN in a non-coupled manner with the flow analysis. In order to take into account much uncertainty in the thermal relaxation, chemical reaction, and ablation models used in the flow analysis, parametric studies were performed by changing these models to obtain the conservative estimation of the radiative environments. The radiative heat flux was found to be considerably affected by the ablation model, especially in the aftbody region of the capsule.
Loading Preview
Sorry, preview is currently unavailable. You can download the paper by clicking the button above.