Ambient aerosol sampling using the Aerodyne Aerosol Mass Spectrometer (original) (raw)
Related papers
Aerosol Science and Technology, 2005
Atmospheric sampling was conducted at a rural site near Egbert, about 70 km north of Toronto, Ontario, Canada from March 27 to May 8, 2003 to characterize the physical and chemical properties of the ambient aerosol in near real-time. The instrumentation included a tapered element oscillating microbalance (TEOM), an ultrafine condensation particle counter (UCPC), a scanning mobility particle sizer (SMPS), an aerodynamic particle sizer (APS), an aerosol mass spectrometer (AMS), and a particulate nitrate monitor (R&P 8400N) for aerosol measurements. Gas-phase non-methane hydrocarbon compounds (NMHCs) were measured by gas chromatograph-flame ionization detection (GC-FID). Filter samples were also collected for analysis of inorganic ions by ion chromatography (IC). Aerosol properties varied considerably depending upon meteorological conditions and airmass histories. For example, urban and industrial emissions advected from the south strongly influenced the site occasionally, resulting in higher particulate mass with the higher fractions of nitrate and organics. Cleaner northwesterly winds carried aerosols with relatively higher fractions of organics and sulfate. The AMS derived mass size distributions showed that the inorganic species in the particles with vacuum aerodynamic diameters between about 60 nm and 600 nm had mass modal vacuum aerodynamic diameters around 400–500 nm. The particulate organics often exhibited two modes at about 100 nm and 425 nm, more noticeable during fresh pollution events. The small organic mode was well correlated with gas-phase nonmethane hydrocarbons such as ethylbenzene, toluene, and propene, suggesting that the likely sources of small organic particles were combustion related emissions. The particulate nitrate exhibited a diurnal variation with higher concentrations during dark hours and minima in the afternoon. Particulate sulfate and organics showed evidence of photochemical processing with higher levels of sulfate and oxygenated organics in the afternoon. Reasonable agreement among all of the co-located measurements is found, provided the upper size limit of the AMS is considered.
Journal of Geophysical Research, 2003
Abstract[1] The aerosol mass spectrometer (AMS), manufactured by Aerodyne Research, Inc., has been shown to be capable of delivering quantitative information on the chemical composition and size of volatile and semivolatile fine airborne particulate matter with high time resolution. Analytical and software tools for interpreting the data from this instrument and generating meaningful, quantitative results have been developed and are presented here with a brief description of the instrument. These include the conversion of detected ion rates from the quadrupole mass spectrometer during the mass spectrum (MS) mode of operation to atmospheric mass concentrations of chemical species (in μg m−3) by applying calibration data. It is also necessary to correct for variations in the electron multiplier performance, and a method involving the measurement of the instrument's response to gas phase signals is also presented. The techniques for applying particle velocity calibration data and transforming signals from time of flight (TOF) mode to chemical mass distributions in terms of aerodynamic diameter (dM/dlog(Da) distributions) are also presented. It is also possible to quantify the uncertainties in both MS and TOF data by evaluating the ion counting statistics and variability of the background signal, respectively. This paper is accompanied by part 2 of this series, in which these methods are used to process and analyze AMS results on ambient aerosol from two U.K. cities at different times of the year.