Automated Measurement of Highly Divergent Optical Wavefronts With a Scanning Shack–Hartmann Sensor (original) (raw)
Related papers
2011
We demonstrated the used of an adaptive optic system in biological imaging to improve the imaging characteristics of a wide field microscope. A crimson red fluorescent bead emitting light at 650 nm was used together with a Shack-Hartmann wavefront sensor and deformable mirror to compensate for the aberrations introduce by a Drosophila embryo. The measurement and correction at one wavelength improves the resolving power at a different wavelength, enabling the structure of the sample to be resolved (510 nm). The use of the crimson beads allow for less photobleaching to be done to the science object of the embryo, in this case our GFP model (green fluorescent beads), and allows for the science object and wavefront reference to be spectrally separated. The spectral separation allows for single points sources to be used for wavefront measurements, which is a necessary condition for the Shack-Hartmann Wavefront sensor operation.
Journal of refractive surgery (Thorofare, N.J.: 1995)
A novel wavefront sensor has been developed. It follows the same principle of the Shack-Hartmann wavefront sensor in that it is based on slope information. However, it has a different symmetry, which may offer benefits in terms of application. The new wavefront sensor consists of a set of donut-shaped acrylic lenses with a charge coupled device located at the focal plane. From detection of shift in the radial direction, radial slopes are computed for 2880 points. Theoretical computations for higher order aberrations and lower order aberrations were implemented for the Shack-Hartmann wavefront sensor and the new wavefront sensor, and practical measurements were conducted on several sphere-cylinder trial lenses. The overall mean value of root mean square error (RMSE) (in microns) for theoretical computations was 0.03 for the Shack-Hartmann wavefront sensor and 0.02 for the new wavefront sensor. The mean value of RMSE for lower order aberrations (1-5) was 0.01 and 0.00003, and for high...
Determination of wavefront structure for a Hartmann wavefront sensor using a phase-retrieval method
Optics express, 2012
We apply a phase retrieval algorithm to the intensity pattern of a Hartmann wavefront sensor to measure with enhanced accuracy the phase structure of a Hartmann hole array. It is shown that the rms wavefront error achieved by phase reconstruction is one order of magnitude smaller than the one obtained from a typical centroid algorithm. Experimental results are consistent with a phase measurement performed independently using a Shack-Hartmann wavefront sensor.