Strain determination of self-adhesive resin cement using 3D digital image correlation method (original) (raw)

3D Digital Image Correlation Analysis of the Shrinkage Strain in Four Dual Cure Composite Cements

BioMed Research International, 2019

The introduction of resin-based cements and an adhesive-bonding system in daily dental practice has given the opportunity to increase the retention of previously conventional cemented restorations and the optimal results in esthetic. This experimental study employed the 3D Digital Image Correlation Method (3D-DIC) for detecting shrinkage strain in four dual cured composite cements. The aim was to visualize measure, analyze, and compare strain fields in four resin-based cements using the 3D-DIC method. A total of 72 samples were divided into 4 groups considering variations in sample types, diameter, and thickness. Four types of composite cements: RelyX U200 (3 M ESPE, St. Paul, MN, USA), MaxCem Elite (Kerr, Orange, CA, USA), Multilink Automix (Ivoclar Vivadent, Schaan, Liechtenstein), and SeT PP (SDI, Australia) were used. Each type had diameters of 3 mm, 4 mm, and 5 mm, respectively, combined with two different values of thickness: 1 mm and 2 mm. Thickness had an important role on s...

Novel testing method to evaluate the mechanical strength of self-adhesive resin cements with reflection of cement thickness

Dental Materials Journal, 2021

This study aimed to propose an evaluation method for testing the mechanical strength of film-formed self-adhesive resin cements (SARCs) while reflecting cement layer thickness. Three commercially available dual-cure type SARCs were used for tensile and shear tests using specimens with varying thicknesses (0.05, 0.2, and 0.4 mm). There were no significant differences in tensile strengths among the various specimen thicknesses. In the shear test, there was a significant decrease in the strength with a reduction in specimen thickness. Stress distribution and fracture patterns were analyzed using in silico nonlinear dynamic finite element analysis. Finite element analysis demonstrated that stress distribution on the specimen surface was homogeneous even with different thicknesses in the tensile test, whereas it was inhomogeneous and induced different fracture patterns on the 0.05-mm-thick specimen in the shear test. These results suggest that the tensile test is useful for testing the mechanical strength of film-formed SARCs.