Wave model verification based on measurements in the Wadden Sea (original) (raw)
Related papers
A validation of an operational wave and surge prediction system for the Dutch Coast
Natural Hazards and Earth System Sciences Discussions, 2014
Knowledge of the actual condition of hydrodynamics in the nearshore and coastal area is essential for coastal monitoring activities. To this end, a coastal operational model system can serve as a tool in providing recent and up-to-date state of the hydrodynamics along the coast. In this paper we apply CoSMoS (Coastal Storm Modeling System), a generic operational model system applied here to predict storm impact on dunes along the Dutch Coast. The CoSMoS application is not limited to storm impact prediction on the Dutch coast, but can also be applied to other coastal hazards such as rip currents and coastal flooding, in other environments. In this paper, we present the set-up of the CoSMoS system and validation of the wave and surge model within it using deep water wave buoy data and tidal gauge measurements as ground truth validation material. The evaluation is presented as monthly error measures between computed parameters and observed ones. Hindcast results over the whole year of ...
East Frisian Wadden Sea hydrodynamics and wave effects in an unstructured-grid model
Ocean Dynamics, 2015
An unstructured-grid model (FVCOM) coupled to a surface wave model (FVCOM-SWAVE) with two different setups is used to investigate the hydrodynamic and wave energy conditions during a moderate and a storm situation in the southern North Sea. One setup covers the whole North Sea with moderately increased grid resolution at the coast while the other setup is a very high resolution Wadden Sea setup that is one-way coupled to the coarser North Sea model. The results of both model setups are validated, compared to each other and analysed with a focus on longshore currents and wave energy. The numerical results show that during storm conditions strong wave-induced longshore currents occur in front of the East-Frisian Wadden Sea islands with current speeds up to 1 m/s. The model setup with the higher resolution around the islands shows even stronger currents than the coarser setup. The wave-current interaction also influences the surface elevation by raising the water level in the tidal basins. The calculated results for the wave energy show big differences between moderate and storm conditions with time-averaged values up to 200 kW/m.
Application of Empirical Wave Run-Up Formulas to the Polish Baltic Sea Coast
PLoS ONE, 2014
Advanced, multidimensional models are typically applied when researching processes occurring in the nearshore. Relatively simple, empirical equations are commonly used in coastal engineering practice in order to estimate extreme wave run-up on beaches and coastal structures. However, they were mostly calibrated to the characteristics of oceanic coasts, which have different wave regime than a semi-enclosed basin like the Baltic Sea. In this paper we apply the formulas to the Polish Baltic Sea coast. The equations were adjusted to match local conditions in two test sites in Międzyzdroje and Dziwnó wek, where beaches are under continuous video surveillance. Data from WAM wave model and coastal gauge stations were used, as well as precise measurements of the beaches' cross-sections. More than 600 run-up events spanning from June to December 2013 were analysed, including surges causing dune erosion. Extreme wave run-up R 2% was calculated and presented as a percentage value indicating what part of the beach was inundated. The method had a root-mean-square error of 6.1 and 6.5 percentage points depending on the test site. We consider it is a fast and computationally undemanding alternative to morphodynamic models. It will constitute a part of the SatBałtyk Operating System-Shores, delivering forecasts of wave run-up on the beaches for the entire Polish coastline.
Investigating the Effect of Wind and Current on Wave Run-Up and Wave Overtopping
2009
This study describes the experimental work and preliminary results of investigations made on the effects of wind and currents on wave run-up and wave overtopping. The tests were carried out in the shallow water wave basin at the DHI (Hørsholm / Denmark). A detailed description of the set-up and measurements will be given followed by a parametric and a regression analysis which aims at the development of reduction factors for wind, current and obliquity. This is done with respect to the existent design formulae in the Eurotop-Manual (2007) and the results are discussed with regard to former investigations. INTRODUCTION In the past, a variety of structures was built to protect the hinterland during high water levels from coastal flooding or river flooding. Common use in practice is the application of smooth sloped dikes as well as steep or vertical walls. Today the knowledge of the design water level, wind surge, wave runup and/or wave 1 Institute for Hydraulic Engineering and Water R...
Modelling of Waves in a Tidal Flat Area in the South-Eastern German Bight
2005
As part of the project PROMORPH funded by the German Federal Ministry of Education and Research the calibration, validation and application of four wave models for the central Dithmarschen Bight are presented in this paper. The models have been coupled to flow models, which is necessary for correctly modelling the wave characteristics in this tidal environment. In the calibration and validation measurements taken by five wave buoys over a period of one month were considered. Using the root mean average error (RMAE) evaluation, the model results are qualified as reasonable to good. Considering the complex hydrodynamic patterns and bathymetry of the area this is satisfactory. The validated models have been applied to analyse the wave height distribution over the area during moderate and storm scenarios. It is shown that during moderate conditions in the sheltered eastern part of the domain only locally generated waves with limited heights occur. During storm conditions wave heights ma...
Journal of Marine Science and Technology, 2015
Information on possible changes in extreme wave heights is needed to determine the future effectiveness and safety of coastal and flood protection structures. In this study, an assessment of possible changes in the extreme wave heights at selected locations along the German Baltic Sea coast has been carried out on the basis of numerical simulations of waves in the western Baltic Sea and regional climate model data for the past and the future (1961-2100). The future climate change signal of significant wave heights with a return period of 200 years mainly depends on: (i) the location, (ii) the climate change scenario run, (iii) the time period of the comparison, and (iv) the approach adopted to calculate the wave climate. The results show increases of up to +0.5 m and decreases of up to -0.5 m of the extreme wave heights. The increases might have considerable effect on the constructional design of coastal and flood protection structures-such as breakwaters, sea dykes, and vertical wa...
Ocean Modelling, 2010
In the future it is believed that extreme coastal flooding events will increase (in frequency and intensity) as a result of climate change. We are investigating the flood risks in the eastern Irish Sea posed by extreme storm events. Here, an 11-year simulation (01/01/1996 -01/01/2007) including wave-current interaction has been validated. These data can then be used to investigate the potential for coastal flooding in the study area.
Coastal Engineering Proceedings, 2011
In the Ems-Dollard estuary at the southern North Sea coast a revaluation of design water levels along the German dykes has become necessary, since the safety margin for sea level rise was increased by 25 cm due to a decision of the Lower Saxon Ministry for Environment and Climate Protection. The upstream part of the estuary is protected against high storm surges by a storm surge barrier. The closure of the barrier effects downstream surge water levels due to partial reflection. Deterministic-mathematical modeling is applied to evaluate design water levels and design wave run-up. Three severe storm surge events have been hindcasted by a cascade of three hierarchical models from the Continental Shelf over the German Bight into the area of interest. The models are forced by non-stationary and spatially varying data of atmospheric pressure, wind velocities and directions available of meteorological model investigations. The verification of the storm surge model with water level observat...
To prevent coastal flooding via the port of Zeebrugge, storm retaining walls need to be designed for which hydrodynamic boundary conditions are required. The wave conditions during an extreme storm event in particular were determined by doing numerical wave penetration modelling. Comparison between both a linear (MILDwave) and a non-linear (Mike 21BW) wave penetration model and comparison with field measurements shows that the influence of a long navigation channel and short crested waves cannot be neglected. Comparison with the regular wave physical model results shows the importance of including an accurate bathymetry.
COASTAL WAVE MODELLING VALIDATION USING NEW FIELD TECHNIQUES
2000
Traditionally wave measurements in coastal areas are made using either wave buoys or pressure sensors deployed at the bottom. In general these equipments work included in monitoring networks in order to support wave climatologic programs. They are also frequently deployed for harbor management purposes. However the collected and saved data are limited for scientific purposes especially in order to make