Simulation of road traffic conditions on a chassis dynamometer (original) (raw)
Related papers
Experimental Comparison of Hub- and Roller-Type Chassis Dynamometers for Vehicle Exhaust Emissions
Energies, 2022
The emissions of vehicles are measured in laboratories with roller-type chassis dynamometers, which simulate road driving resistances. Hub-coupled dynamometers, which are not included in the regulations for emission measurements, are commonly used for research and development purposes, for example, to assess powertrain capabilities, simulate on-road trips, and calibrate the control of individual wheels. As they do not need particular infrastructure and offer a wider range of applications, they could be a more economical alternative, especially if they could also be used for emission measurements for the type approval of vehicles. Nevertheless, the two types have not been directly compared in the literature, and, thus, their equivalency, especially regarding emission measurements, is not known. In this study, the emissions of a diesel and a gasoline plug-in vehicle were compared using the same analytical equipment and by switching only the roller and hub dynamometers. The diesel vehi...
Combustion Engines, 2019
Air pollution is a challenge for municipal authorities. Increased emission of PM10 and PM 2.5 particles is particularly noticeable in Poland primarily the autumn and winter period. That is due to the start of the heating season. According to the above data, road transport accounted for approximately 5% of the creation of PM10 particles, ca. 7% of PM2.5 and approximately 32% for NOx. In Poland, suspended particles (PM10 and PM2.5) cause deaths of as many as 45,000 people a year. The issue of smog also affects other European cities. Therefore, it is necessary to undertake concrete efforts in order to reduce vehicle exhaust emissions as much as possible. It is therefore justifiable to reduce the emission of exhaust pollution, particularly NOx, PM, PN by conventional passenger cars powered by compression ignition engines. Emissions by these passenger cars have been reduced systematically. Comparative tests of the above emission of exhaust pollution were conducted on chassis dynamometer ...
Combustion Engines, 2019
The results of measurements of exhaust emissions in real road traffic differ significantly from the results of stationary homologation tests. One of the solutions, helpful in determining the actual emission, is the creation of stationary exhaust emission tests simulating the use of the vehicle on the road. The article presents the method of reconstructing the synthetic driving test obtained on the basis of road tests and presents the obtained profile of the speed course. The authors discussed the reasonableness of selecting the emission component determining the correctness of the representativity of the stationary test obtained, which determines the amount of work done by the engine.
Accuracy of exhaust emission factor measurements on chassis dynamometer
2009
Abstract To improve the accuracy, reliability, and representativeness of emission factors, 10 European laboratories worked together to study the influence of 20 parameters on the measurement of light-vehicle emission factors on chassis dynamometer of 4 main categories: driving patterns, vehicle-related parameters, vehicle sampling, and laboratory-related parameters. The results are based on (1) literature synthesis,(2) approximately 2700 specific tests with 183 vehicles, and (3) the reprocessing of more than 900 tests.
Energies
Air pollution caused by vehicle emissions has raised serious public health concerns. Vehicle emissions generally depend on many factors, such as the nature of the vehicle, driving style, traffic conditions, emission control technologies, and operational conditions. Concerns about the certification cycles used by various regulatory authorities are growing due to the difference in emission during certification procedure and Real Driving Emissions (RDE). Under laboratory conditions, certification tests are performed in a ‘chassis dynamometer’ for light-duty vehicles (LDVs) and an ‘engine dynamometer’ for heavy-duty vehicles (HDVs). As a result, the test drive cycles used to measure the automotive emissions do not correctly reflect the vehicle’s real-world driving pattern. Consequently, the RDE regulation is being phased in to reduce the disparity between type approval and vehicle’s real-world emissions. According to this review, different variables such as traffic signals, driving dyna...