Magnetization Reversal in Concave Iron Nano-Superellipses (original) (raw)
Related papers
Magnetization reversal induced by irregular shape nanodots in square arrays
Journal of Magnetism and Magnetic Materials, 2010
Ni 80 Fe 20 nanodots in square arrays of irregular shape (C 1h (m) and x-, y-translations symmetry) and circular shape (D 4h (4/mmm)) nanodots of the same area were fabricated under controlled exposure conditions by e-beam lithography, ion beam sputtering coating and further lift-off. The center-to-center nearest dot distances was 700 nm in all the measured arrays. An unpatterned film was fabricated in the same IBS batch for comparison purposes. Structures and magnetic properties were characterized using AFM, SEM and high-sensitivity focused magneto-optical Kerr effect (MOKE). The mechanism of the magnetization reversal of arrays is discussed in two different scenarios: vortex and single-domain. It has been shown that circular dots reverse only through vortex configuration whereas the irregular does either via single-domain and vortex configuration, depending of the dot size. Variable domain phases are confirmed by OOMMF (Object Oriented Micromagnetic Framework) micromagnetic simulations.
Magnetization ground state and reversal modes of magnetic nanotori
Journal of Applied Physics, 2016
In this work, and by means of micromagnetic simulations, we study the magnetic properties of toroidal nanomagnets. The magnetization ground state for different values of the aspect ratio between the toroidal and polar radii of the nanotorus has been obtained. The hysteresis curves are also obtained, evidencing the existence of two reversal modes depending on the geometry: a vortex mode and a coherent rotation. A comparison between toroidal and cylindrical nanoparticles has been performed evidencing that nanotori can accommodate a vortex as the ground state for smaller volume than cylindrical nanorings. This is important because if vortices are used as bits of information, nanotori allow a higher density data storage.
Magnetization reversal in elongated Fe nanoparticles
Physical Review B, 2005
Magnetization reversal of individual, isolated high-aspect-ratio Fe nanoparticles with diameters comparable to the magnetic exchange length is studied by high-sensitivity submicron Hall magnetometry. For a Fe nanoparticle with diameter of 5 nm, the magnetization reversal is found to be an incoherent process with localized nucleation assisted by thermal activation, even though the particle has a single-domain static state. For a larger elongated Fe nanoparticle with a diameter greater than 10 nm, the inhomogeneous magnetic structure of the particle plays important role in the reversal process.
Reversal mechanisms in perpendicularly magnetized nanostructures
Physical Review B, 2008
We demonstrate that magnetic reversal in perpendicularly magnetized nanostructures is highly dependent on the nature and condition of the edges. To understand the impact of edge damage, we compare nanostructures created by ion milling to those prepared on prepatterned substrates. The size-and temperature-dependent reversal properties of 25 nm-1 m diameter nanodots show that reversal in prepatterned nanostructures is controlled by nucleation within the interior, whereas ion milling results in an edge nucleation process with an unpredicted temperature dependence of the reversal field.
Journal of Applied Physics, 2013
Different types of reversal processes, including either uniform-rotation or domain-wall driven processes, were indentified in magnetic nano-wires of four-fold symmetry using micromagnetic simulations. Iron wires were tested for diameters ranging from 6 nm up to 20 nm, while their lengths were taken from 30 nm to 70 nm range, and for several directions of externally applied magnetic field. Physical parameters of presented low-dimensional structures enabled reversal via intermediate states, which can lead to additional stable states at remanence, contrary to instable vortexes observed in magnetic nano-rings or cylindrical nanodots. V C 2013 American Institute of Physics. [http://dx.
Controlling the magnetization reversal in planar nanostructures with wire-ring morphology
Magnetization reversal in planar nanowires has been controlled using structures with a larger area pad connected to a nanowire or by means of patterned variations in the planar nanowire, such as notches. In this paper we have introduced a magnetic nanostructure defined as a planar nanostructure with wire-ring morphology. In particular, we have performed micromagnetic simulations to investigate how the magnetic properties (coercivity and remanence) change as a function of the geometric parameters of the nanostructure. Additionally, we observe that when the ring is very thin, the system reverses its magnetization by nucleation and propagation of domain walls along the nanowire. Conversely, when the ring has very thick walls, or directly turns into a solid cylinder, the system nucleates a vortex in the ring/cylinder, and then propagates the domain walls toward the nanowire sections. This reversal process is characterized by a step or plateau in the hysteresis curve, that is, a region in which differential magnetic susceptibility presents a local minimum or, ideally, vanishes. Finally, this nanostructure can be used in many potential applications related to the control of domain walls in planar nanowires.
Journal of Applied Physics, 2011
We report on the experimental and theoretical investigation of the magnetization reversal in magnetic nanotubes that have been synthesized by a combination of glancing angle and atomic layer deposition. Using superconducting quantum interference device magnetometry the angular dependence of the coercive fields is determined and reveals a nonmonotonic behavior. Analytical calculations predict the crossover between two magnetization reversal modes, namely, the movement of different types of domain boundaries (vortex wall and transverse wall). This transition, already known in the geometrical dependences of the magnetization reversal in various nanotubes, is found within one type of tube in the angular dependence and is experimentally confirmed in this work.
Magnetization Reversal of Rectangular Particles: Closure States and Effect of Dipolar Coupling
IEEE Transactions on Magnetics, 2012
We have investigated the magnetization configurations of ferromagnetic rectangular particles with lateral dimensions 1025 450 nm 2 and two different thicknesses: 10 and 40 nm. For each thickness, we analyzed both an array consisting of isolated particles and a second one where the nanomagnets are put head-to-tail, with 85 nm interdot spacing, forming long chains of closely-spaced elements. Magnetooptical Kerr effect measurements and in-field magnetic force microscopy experiments were performed to achieve a deep comprehension of the magnetization reversal process. It is shown that inter-particle dipolar coupling substantially modifies the reversal mechanism in the case of the largest thickness, where it can delay or even suppress the occurrence of closure configurations of the magnetization (with one or more vortices), that are typical of isolated nanomagnets.