INFLUENCE OF WATER DEPTH ON THE PERFORMANCE OF A DUAL PURPOSE SINGLE BASIN DOUBLE SLOPE SOLAR STILL (original) (raw)
Related papers
Experimental Investigation Of The Performance Of Basin Type Single-Slope Solar Still
The supply of drinking water is a growing problem especially for developing countries. Solar stills have been considered as one of the viable options of converting brackish or dirty water into distil water. Basin water depth is one of the design and operating parameters that determines the performance of solar still. Therefore, three identical simple basin single slope solar stills A, B, and C were constructed and their performance was experimentally investigated under the same conditions at basin water depths of 5mm, 10mm and 20mm respectively. The distillate productivity, solar intensity, and the temperatures of the basin water, glass cover and the ambient of the three stills were measured and their relationships were investigated. The heat losses as well as the experimental and thermal efficiencies of the stills were estimated. The results reveal that still A demonstrates high performance followed by still B. This however indicates that the performance of a solar still is high at...
EXPERIMENTAL ANALYSIS OF A SINGLE SLOPE SINGLE BASIN SOLAR STILL WITH HOT WATER PROVISION
In this paper present has been worked in design, fabricate and experimental analysis of single slope single basin solar still. These models have been developed based on purified water and hot water. The experimental analysis of a single slope single basin solar still is affected by design and parameters like water temperature, basin liner temperature, hot water temperature, glass cover temperature, ambient temperature and solar intensity. The experimental analysis of the system has been measured 24 hours output values 4.915 kg/m 2 and hot water 45.500 kg/m 2 . The facile approaches analysis has been carried out for natural circulation of water temperature sunny hour's (11.00am to 3.00pm) continuous output temperature 53C, respectively. The experimental calculations have been made for one of the typical days under in Chennai at Manimangalam climatic condition.
THERMAL MODELLING AND PERFORMANCE STUDY OF MODIFIED DOUBLE SLOPE SOLAR STILL
Solar distillation is a process of producing purified drinking water from brackish water by using the heat of solar radiation as the feed to evaporate the impure water which on condensation gives the pure water. It is independent of electricity, a major portion of which is generated from fossil fuel causing environmental pollution and relies completely on renewable source of energy like solar radiation, thus making it environment friendly. In this paper a modified double slope solar still (modified DSSS) has been designed by using Transparent Acrylic and opaque Fibre Reinforced Plastic (FRP) as its body material with two toughened glass covers. The basin and north wall of modified DSSS have been made by using FRP of thickness (0.005 m), whereas, its three sides (East, West and South walls) are made of transparent Acrylic sheet of thickness (0.003 m) equivalent to that of FRP for the same heat loss, which results in increased input solar radiation inside the solar still and improved performance but with low cost. It is evident that, the inside space of solar still is filled with air and vapour molecules which can come in contact with inner surfaces of walls and glass covers. The vapour molecules close to the walls strike it due to molecular collisions and stick to it to release its heat for phase change from vapour to liquid during condensation process. Hence, five troughs (distillate collecting channels) have been placed at inside surfaces of all its walls and glass covers. The yield has been collected from all the sides of the solar still except north wall which acts heat absorber. The molecules which come in contact with north wall get additional heat from it and get evaporated. In this paper, a thermal model has been developed to predict theoretically the performance of MDSSS for the climatic condition of MNNIT, Allahabad, India on 22 nd May 2014. Expressions for water and glass temperatures and hourly yield for the modified double slope solar distillation system have been derived analytically. It has been found that the total yield obtained from the MDSSS in a period of 24 hour is 16 Kg of purified water from 25 Kg of brackish water which is about twice of that obtained from conventional solar stills. Also the effect of solar radiation on the productivity of solar still has been analyzed.
Journal of Al-Nahrain University-Science
The most prominent factors that have a significant influence on the performance of solar distillation are the inclination angle of the solar still cover and the water depth within the still basin. This paper was investigated an experimental performance of a single solar still. Five single sloped solar stills were designed and fabricated to operate under Baghdad city weather condition during August 2016. The inner dimensions of each basin were 0.5x0.5 m. The glass covers were tilted at 20 o , 31 o , 45 o and 50 o with respect to the horizontal. The temperatures of the outer glass covers surfaces were measured. Also, this study presents an experimental investigation on the potable water collection amount with the water depths of 1, 2, 3, 5, and 7 cm into each still basin and the different glass lid inclination angles. The hourly amount of extracted drinkable water was monitored. The daily produced amounts of fresh water increased by reducing the tilt angle from 50 o to 20 o , and diminish of water depth in the basin from 7 cm to 1 cm. The highest total daily amount was 495 ml/day (~2 l/m 2 /day) for solar still with tilt angle of 20 o and water depth of 1 cm.
EXPERIMENTAL STUDY OF A SINGLE BASIN SOLAR STILL WITH WATER COOLING OF THE GLASS COVER
A single basin solar still is a simple device to produce drinking water from easily available saline water. Because of its low productivity it is not popularly used. A lot of research work is undertaken to improve the productivity of the still. Heat transfer in a solar still mainly depends on the temperature difference between the evaporative water surface and the condensing surface for a given surface area. An attempt has been made to increase the temperature difference by reducing the condensing surface temperature. In this regard two similar, single basin double slope solar stills are taken for our study. Experimentation is performed in the premises of SHIATS-DU Allahabad. 17% gain is recorded in the distillate output due to cooled condensing cover
Theoretical Analysis of Water Distillation Using Solar Still
Academic Journals, 2009
In developing countries, lack of safe and unreliable drinking water constitutes a major problem. To alleviate this problem, a solar still was designed and tested in Mubi, Adamawa State of Nigeria. The radiation from the sun evaporates water inside the solar still at a temperature higher than the ambient. The principle of operation is the greenhouse effect provided with the glass cover. Energy balances are made for each element of the still; solar time, direction of beam of radiation, clear sky radiation, optical properties of the cover, convection outside the still, convection and evaporation inside are accounted. Theoretical analysis of the heat and mass transfer mechanisms inside this solar still has been developed. The measured performance was then compared with results obtained by theoretical analysis. The results clearly show that the instantaneous efficiency increases with the increase of solar radiation and with the increase of feed water temperature. The distillation efficiency of the still is 99.64% as compared to the theoretical analysis.
Evaluation of basin type solar still by optimizing the condenser
International Journal of Advance Research, Ideas and Innovations in Technology, 2019
Productivity enhancement of solar still has been one of the main goals of the researchers. The purpose of this research is to design a water distillation system that can purify water from nearly any source, a system that is relatively cheap, portable, and depends only on renewable solar energy. To improve the performance external condenser was used. In this research work, two design of solar still was compared experimentally, one with external condenser and other without condenser. The effect of adding external condenser to the still is to decrease the heat loss. To improve this the addition of external condenser in simple solar still was definitely a positive in improving the thermal performance of the still by increasing the overall water collection over 24 h. This paper contains the experimental work and comparison.
Performance Evaluation of Single Slope Solar Still by Integrating with Solar Thermal Systems
Asia Pacific Journal of Energy and Environment, 2018
The world is facing the state of being scarce of fresh or drinking water and it is the major problem and global challenge. Along with air and food, water is a basic necessity for human. Solar energy is the biggest source of energy available on earth. A solar distillation is one of the methods for purifying salt water to drinking water. In this method fresh water is obtained by exposing a small layer of salt water to solar radiation and the water vaporized from the basin is condensed on the bottom side of a taper transparent cover. It can be collected in receiving troughs at the end of the still. For this research, a solar still has been designed, fabricated and tested under the climate condition of Coimbatore (11.01680 N, 76.9550 E), India from December 2016 to March 2017. The still basin area was 1m2 and the glass cover of still is inclined at 13 degree based on the city latitude. Solar still is integrated with thermal system such as solar photovoltaic system and then with solar pond in order to preheat the feed water thereby increasing the productivity considerably. Experiments were carried out on the still using different parameters and tested for performance. The results showed that the daily production of the conventional solar still was 2 Lit/m2/day and integrated with photovoltaic system and solar pond was 3.1 Lit/m2/day and 2.54 Lit/m2/day respectively.
Performance analysis of a double-slope solar still with elevated basin - comprehensive study
DESALINATION AND WATER TREATMENT, 2021
Solar distillation is an effective method of generating potable fresh water in areas where there is abundant sunshine with adequate water that is unfit for human consumption or other activities. In the current study, an experimental and theoretical analysis was performed to evaluate the productivity of a modified solar still having an elevated basin. This improvement was achieved by raising the basin inside the distiller. The elevated basin helps in reducing the thermal losses from the bottom and sides of the distiller because the air gap between the basin and both the bottom and sides of the distiller acts as an insulator. All tests were carried out under the weather conditions of the Baghdad-Iraq region during the months of February, March, April, and May. The average distilled water outputs per square meter for the experimental period were 3.03 and 4.37 L for the conventional solar still (CSS) and elevated-basin solar still (EBSS), respectively. The average percentage increment in the fresh water production from the EBSS was found to be 36.7% (relative to that of the CSS). It was evident that the theoretical model predicted the trends very well, with some deviations from the experimental values. The average difference between the theoretical and experimental findings in total productivity was found to be between 4% and 8%. The estimated average cost of the distillate water was $0.027/L m 2 for the EBSS.
DEVELOPMENT AND PERFORMANCE EVALUATION OF A SOLAR WATER STILL
The availability of potable water is a necessity for human existence. A simple laboratory scale solar water still capable of holding 75 litres of water has been developed and evaluated. The highest temperature in the solar still occurred at the vapour region and reached up to 66°C. The productivity of the solar still varies with the depth of water in the still. The results of the productivity were 67.4 ml/m 2 h, 54.2 ml/m 2 h and 43.4 ml/m 2 h for depths of 20 mm, 40 mm and 60 mm respectively. The efficiency of the solar still was found to vary with the depth of water in the basin. The highest efficiency obtained for the solar still was 29.1% at a depth of 20 mm. Characterization of water quality before and after distillation in the solar still showed a reduction in chemical and microbiological constituents after distillation which was comparable to standard drinking water. The solar still could be developed at a small-scale workshop at reasonably cheap costs. Further work to improve the productivity of the solar water still is proposed. INTRODUCTION Supply of potable water is a major problem particularly in developing countries. The problem often faced is that protected or improved sources, such as boreholes and treated urban supplies, can still be contaminated such that microbiologically unsafe water is delivered [1]. Of major concern is the populace dwelling in rural regions of developing countries who do not have access to these improved sources and are at higher health risks as they depend on the natural sources like rivers, streams and springs which are often contaminated. The ability to be able to treat water on a domestic scale will therefore be of immense benefit. Nigeria lies within a high sunshine belt and solar radiation is fairly well distributed within the country. The annual average total solar radiation varies from 12.6 MJ/m 2-day in the coastal latitudes to 25.2MJ/m 2-day in the far north [2]. This vast amount of solar energy could be utilized in purifying water domestically. Solar distillation has been largely used in desalination. It involves utilizing solar energy for heating of water to cause evaporation. The vapour produced, then, condenses to produce distilled water. Gomkali and Datta [3] designed a simple solar still with a double-sloped glass cover plate which had an annual average productivity of 2.5 l/m 2-day and at an efficiency of 28%. Naim [4] also devised a single-stage solar desalination spirally-wound module which had maximum distillation efficiency of 34% and with a productivity of 575 ml/m 2-h. Medugu and Malgwi [5] designed and tested a solar still and claimed that the instantaneous efficiency increases with the increase of solar radiation and with increase of feed water temperature. Tarawneh [6] studied the effect of water depth on the performance evaluation of a solar still and stated that decreased water depth has a significant effect on increased water productivity, noting that the productivity of