Magnetic soft silicone elastomers with tunable mechanical properties for magnetically actuated devices (original) (raw)
2020, Polymers for Advanced Technologies
Funding information Natural Sciences and Engineering Research Council of Canada; Fonds de recherche du Québec-Nature et technologies Polydimethylsiloxane (PDMS)/iron oxide magnetic nanoparticle (NP) composites with tailored mechanical properties are prepared for use in magnetically actuated soft devices based on their controlled deformation by the application of an external magnetic field. This investigation reports the synthesis and functionalization of iron oxide NPs, the preparation of the PDMS/NP composites, the evaluation of NP dispersion using scanning electron microscopy (SEM) and optical microscopy, and the mechanical characterization of the composite films. Characterization includes rheological measurements as well as stress-strain curves to obtain the Young modulus and elongation at break. SEM is used to probe individual NP dispersion, whereas optical microscopy provides rapid access to quantitative information about the size and distribution of particle aggregates. Results for nonfunctionalized (nf), oleic acid (OA)coated, and stearic acid (SA)-coated iron oxide NPs and their blends are presented. PDMS elastomers containing both OA-and SA-coated iron oxide NPs are found to have very low Young moduli with substantially higher resistance to failure than neat PDMS. For example, a formulation containing 2.5 wt% OA-coated NPs and 2.5 wt% SA-coated iron oxide NPs has a modulus of 0.15 MPa (compared with 0.24 MPa for neat PDMS), while it can withstand an elongation of about 1.5 times its initial length compared with only 0.3 times for neat PDMS. As a comparison, the modulus of the most commonly used commercial PDMS elastomer (Sylgard 184) is an order of magnitude higher than that of the composites prepared here, whereas maximum elongation is similar for the two. The formulations developed in this work could be used in applications where high deformability is required with limited magnetic field strength and/or NP loading.
Sign up to get access to over 50M papers
Sign up for access to the world's latest research
Related papers
Magnetoactive elastomer composites
Polymer Testing, 2004
This paper deals with the development of magnetoactive elastomers and the exploration of some of their potential applications. In the course of material development, samples of particle-filled silicone rubber were produced and their mechanical and magnetic properties were experimentally determined. The test specimens consisted of pure and filled silicone with randomly dispersed as well as aligned magnetizable particle chains. To align the embedded particles in the elastomer, cross-linking of the resin took place in a magnetic field. Composite elastomer samples with different types of micron-size particles and various volume fractions were tested. Through alignment of the embedded particles, relative to pure silicone, the tensile strength increased by 80%, the tensile modulus by 200%, and the compression modulus by more than 300%. The maximum tensile strain of filled samples was generally reduced; however, samples with longitudinally aligned particles retained a relatively high strain capability as in the pure silicone rubber. Furthermore, to determine the active response of the composite, magnetic tests and coupled mechanical-magnetic experiments were performed. The magnetoactive elastomer composites produced and tested in this work demonstrated certain actuator force properties. The equivalent magnetic force calculated on the basis of these experiments and the magnetosolid mechanics theory showed the dependence of the magnetic force on the distribution of the particles in the elastomer. The elasto-magnetic behavior of beam samples was investigated by exposing the filled elastomer to the action of a permanent magnet at various gap distances, which led to the determination of a so-called magnetic bending stiffness. Moreover, through these experiments the influence of the particle alignment on the critical gap distance of the elastomagnetic instability of composite elastomer was quantitatively estimated. The compression tests on cylindrical samples in the absence and the presence of a magnetic field showed that the magnetic field would increase the stiffness of the material. These experiments lead to useful hints regarding the use of such elastomer composites as tunable force structural elements.
Plasticity of soft magnetic elastomers
Polymer Science Series A, 2010
A simple rheological model is introduced to describe the plasticity in soft magnetic elastomers induced by an external field. In addition to the elasticity of the polymer matrix, the effect of dry friction (plas ticity), which is provided by the rearrangement of the spatial structure of a dispersed magnetic subsystem in the course of the deformation of the material by a sufficiently strong field, is taken into account in the model. Model parameters are estimated from the reported experimental data on the deformation of cylindrical sam ples based on a soft silicon elastomer filled with quasispherical microparticles of carbonyl iron.
Magnetic Hybrid-Materials, 2021
Hybrid magnetic elastomers (HMEs) belong to a novel type of magnetocontrollable elastic materials capable of demonstrating extensive variations of their parameters under the influence of magnetic fields. Like all cognate materials, HMEs are based on deformable polymer filled with a mixed or modified powder. The complex of properties possessed by the composite is a reflection of interactions occurring between the polymer matrix and the particles also participating in interactions among themselves. For example, introduction of magnetically hard components into the formula results in the origination of a number of significantly different behavioral features entirely unknown to magnetorheological composites of the classic type. Optical observation of samples based on magnetically hard filler gave the opportunity to establish that initial magnetization imparts magnetic moments to initially unmagnetized grains, as a result of which chain-like structures continue to be a feature of the material even after external field removal. In addition, applying a reverse field causes them to turn into the polymer as they rearrange into new ring-like structures. Exploration of the relationship between the rheological properties and magnetic field conducted on a rheometer using vibrational mechanical analysis showed an increase of the relative elastic modulus by more than two orders of magnitude or by 3.8 MPa, whereas the loss factor exhibited steady growth with the field up to a value of 0.7 being significantly higher than that demonstrated by elastomers with no magnetically hard particles. At the same time, measuring the electroconductivity of elastomers filled with a nickel-electroplated carbonyl iron powder made it possible to observe that such composites demonstrated an increase of variation of the resistivity of the composite influenced by magnetic field in comparison to elastomers containing untreated iron particles. The studies conducted indicate that this material exhibits both magnetorheological and
Magnetorheological effect of magneto-active elastomers containing large particles
Journal of Physics: Conference Series, 2009
The magnetorheological effect of elastomer composites containing a mixture of large (50-80 μm) and small (3-5 μm) particles has been experimentally examined. The data shows that elasticity in the range of small deformations (1%) for a magnetic field strength of 290 mT increased by two order of magnitude. This effect can be explained with the presence of the large particles in the structure of the composite assisting the aggregation effect. Due to the strong increase of the interparticle interaction compared with the restoring elastic forces, the presence of the large particles leads to the observed steep increase of Young's modulus.
A highly tunable silicone-based magnetic elastomer with nanoscale homogeneity
Journal of Magnetism and Magnetic Materials, 2012
Magnetic elastomers have been widely pursued for sensing and actuation applications. Siliconebased magnetic elastomers have a number of advantages over other materials such as hydrogels, but aggregation of magnetic nanoparticles within silicones is difficult to prevent. Aggregation inherently limits the minimum size of fabricated structures and leads to non-uniform response from structure to structure. We have developed a novel material which is a complex of a silicone polymer (polydimethylsiloxane-co-aminopropylmethylsiloxane) adsorbed onto the surface of magnetite (γ-Fe 2 0 3) nanoparticles 7-10 nm in diameter. The material is homogenous at very small length scales (< 100 nm) and can be crosslinked to form a flexible, magnetic material which is ideally suited for the fabrication of micro-to nanoscale magnetic actuators. The loading fraction of magnetic nanoparticles in the composite can be varied smoothly from 0-50% wt. without loss of homogeneity, providing a simple mechanism for tuning actuator response. We evaluate the material properties of the composite across a range of nanoparticle loading, and demonstrate a magnetic-field-induced increase in compressive modulus as high as 300%. Furthermore, we implement a strategy for predicting the optimal nanoparticle loading for magnetic actuation applications, and show that our predictions correlate well with experimental findings.
Physical Sciences Reviews, 2020
Hybrid magnetic elastomers (HMEs) belong to a novel type of magnetocontrollable elastic materials capable of demonstrating extensive variations of their parameters under the influence of magnetic fields. Like all cognate materials, HMEs are based on deformable polymer filled with a mixed or modified powder. The complex of properties possessed by the composite is a reflection of interactions occurring between the polymer matrix and the particles also participating in interactions among themselves. For example, introduction of magnetically hard components into the formula results in the origination of a number of significantly different behavioral features entirely unknown to magnetorheological composites of the classic type. Optical observation of samples based on magnetically hard filler gave the opportunity to establish that initial magnetization imparts magnetic moments to initially unmagnetized grains, as a result of which chain-like structures continue to be a feature of the mat...
Field-induced plasticity of soft magnetic elastomers
Journal of Physics: Conference Series, 2009
A phenomenological model is proposed to describe the plasticity of soft magnetic elastomer composites under an external field. Along with high-elasticity, internal dry friction is introduced whose origin is attributed to the dipole-dipole interaction of the embedded particles. Numerical estimates of the model parameters are obtained from comparison with the measurements performed on iron carbonyl dispersions in soft silicon-rubber matrices.
Magnetic and viscoelastic response of elastomers with hard magnetic filler
Magnetic elastomers (MEs) based on a silicone matrix and magnetically hard NdFeB particles have been synthesized and their magnetic and viscoelastic properties have been studied depending on the size and concentration of magnetic particles and the magnetizing field. It has been shown that magnetic particles can rotate in soft polymer matrix under applied magnetic field, this fact leading to some features in both magnetic and viscoelastic properties. In the maximum magnetic field used magnetization of MEs with smaller particles is larger while the coercivity is smaller due to higher mobility of the particles within the polymer matrix. Viscoelastic behavior is characterized by long relaxation times due to restructuring of the magnetic filler under the influence of an applied mechanical force and magnetic interactions. The storage and loss moduli of magnetically hard elastomers grow significantly with magnetizing field. The magnetic response of the magnetized samples depends on the mutual orientation of the external magnetic field and the internal sample magnetization. Due to the particle rotation within the polymer matrix, the loss factor increases abruptly when the magnetic field is turned on in the opposite direction to the sample magnetization, further decreasing with time. Moduli versus field dependences have minimum at non-
Loading Preview
Sorry, preview is currently unavailable. You can download the paper by clicking the button above.