A Study of the Influence of Percentage of Copper on the Structural and Optical Properties of Au-Cu Nanoparticle (original) (raw)
Related papers
Summer and Autumn 2016-Cu Nanoparticle
2016
Here we present our experimental results in synthesizing Au-Cu nano-particles with tunable localized surface plasmon resonance frequency through wetchemical at temperature room. The reaction is performed in the presence of ascorbic acid as a reducing agent and polyvinyl pyrrolidone as capping agent via four different procedures: (1) mixture of 90% HAuCl 4 and 10% CuSO 4 .5H 2 O precursors, (2) mixture of 75% HAuCl 4 and 25% CuSO 4 .5H 2 O precursors, (3) mixture of 50% HAuCl 4 and 50% CuSO 4 .5H 2 O precursors (4) mixture of 25% HAuCl 4 and 75% CuSO 4 .5H 2 O precursors. Effect of different percentages of Cu on Au nanoparticles has been analyzed using X-ray diffraction (XRD), scanning electron microscopy (SEM with EDAX analysis), DRS UV-Vis, and Fourier transform IR spectra (FTIR) analysis. X-ray diffraction (XRD) analysis revealed that the nanoparticles are of cubic structure without an impure phase. The successful doping of the Cu into the Au host was evident by XRD line shiftings...
TEM characterization of chemically synthesized copper–gold nanoparticles
Journal of Nanoparticle Research, 2011
Dodecanethiol-capped Cu-Au nanoparticles, synthesized via a successive two-phase (water/ toluene) and galvanic-exchange procedure, were characterized using transmission electron microscopy (TEM). The size range of the particles is around 1-7 nm. Electron-induced morphological evolution was observed under high resolution (HR) TEM. Cuboctahedral morphology was found to be thermodynamically stable. Electron-induced aggregation of two particles was also observed. Chemical ordering of cuboctahedral particles was studied by atomicresolution high angle annular dark field (HAADF) imaging in scanning TEM (STEM) mode and energy dispersive X-ray (EDX) element mapping using a silicon drift detector (SDD). The particles were found to be Cu-Au mixed, and to be stable in air. Surface plasmon resonance (SPR), which is dependent on local structure and morphology, was investigated by electron energy loss spectroscopy (EELS).
Due to scientific and industrial interest, copper nanoparticles have attracted a lot of interest in the current decade, special due to its applications in antibiotic , anti-microbial and anti-fungal agent, catalysis, conductive inks, coatings, coolant and textiles. The present study focused, on the cost effective synthesis technique and environmental effects on copper nanoparticlesdue to its high surface sensitivity. The structural composition, particle size and optical properties of copper nanoparticleswere determined by X-raysand UV-Visible spectroscopy, reveals that the particles have size in order to 9 nm. A plasmonic study through a UV-visible spectrum shows the peak shift from 411 to 316 nm, with color change in the coppernanoparticles indicate the surface sensitivity due to very large surface area.The synthesis method, reported in current work might be useful for industrial production of Cu nanoparticles.
Nano Letters, 2020
We report a heterometallic seed-mediated synthesis method for monodisperse penta-twinned Cu 2 nanorods using Au nanocrystals as seeds. Elemental analyses indicate that resultant nanorods consist predominantly of copper with a gold content typically below 3 at. %. The nanorod aspect 4 ratio can be readily adjusted from 2.8 to 13.1 by varying the molar ratio between Au seeds and Cu 5 precursor, resulting in narrow longitudinal plasmon resonances tunable from 762 to 2201 nm. 6 Studies of reaction intermediates reveal that symmetry-breaking is promoted by rapid nanoscale 7 diffusion in Au-Cu alloys and the formation of a gold-rich surface. The growth pathway features 8 co-evolving shape and composition whereby nanocrystals become progressively enriched with Cu 9 concomitant with nanorod growth. The availability of uniform colloidal Cu nanorods with widely 10 tunable aspect ratios opens new avenues toward the synthesis of derivative one-dimensional metal 11 nanostructures, and applications in surface-enhanced spectroscopy, bioimaging, electrocatalysis, 12 among others. ASSOCIATED CONTENT 1 Supporting Information. Experimental section, structural characterization of Cu NRs, FDTD 2 simulation results and studies of reaction intermediates are included. This material is available free 3 of charge via the Internet at http://pubs.acs.org.
Development of Au/CuO nanoplasmonic thin films for sensing applications
Surface and Coatings Technology, 2018
Nanocomposite thin films, containing Au nanoparticles dispersed in a CuO matrix, were prepared by reactive DC magnetron sputtering and post-deposition thermal annealing. The CuO matrix was found to be stoichiometric and the atomic concentration of Au was determined to be about 12.3 at.%. After the annealing process, the average size of the crystalline domains of the Au nanoparticles (fcc structure) increased from about 6 nm (at an annealing temperature of 300 ºC) to approximately 13 nm (after annealing at 800 ºC), with a progressive crystallization of the CuO matrix in the monoclinic structure. A nanoplasmonic effect due to the localized surface plasmon resonance (LSPR) phenomenon appeared in the films after annealing temperatures of 400 °C and higher. The correspondent LSPR bands appeared in the visible range of the transmittance spectra, becoming progressively narrower. Angle Resolved X-Ray Photoelectron Spectroscopy results indicated that the surface of Au/CuO nanocomposite thin film is contaminated with a sub-nanometric layer (~0.6 nm) of hydrocarbons and that the Au nanoparticles are relatively homogenously dispersed inside the CuO dielectric matrix. Furthermore, the results seem also to indicate that the Au nanoparticles are covered with about 0.2 nm of
Preparation, characterization and surface modification of Cu metal nanoparticles
Chemical Physics Letters, 2002
Copper metal nanoparticles have been formed by irradiation with 253.7 nm light from a low pressure Hg-arc lamp in the presence of a protective agent gelatin. The nanoparticles were characterized by their absorption maxima and transmission electron micrographs. The quantum yields of formation of the metal nanoparticles increase in the presence of the stabilizer as well as in the presence of a photosensitizer, benzophenone (BP). Damping of copper plasmon absorption band was not observed in the presence of benzotriazole. Ó 2002 Published by Elsevier Science B.V.
Evaluation of Optical Properties of Ag, Cu, and Co Nanoparticles Synthesized in Organic Medium
Acta Physica Polonica A, 2013
The surface plasmon resonance evaluation of colloidal metal nanoparticles, synthesized in organic medium, is reported in this work. Metal salts were dissolved in dioxane/AOT solution and reduced by hydrazine hydrate under vigorous stirring. Optical properties of obtained colloidal nanoparticles were investigated by UVVIS spectroscopy. Theoretical predictions of optical properties of metal nanoparticles were made by means of the Mie theory and the Drude free-electron model. Geometrical parameters and distribution of metal nanoparticles in colloidal solutions were characterized by atomic force microscopy. The results show that Ag, Cu, and Co nanoparticles, synthesized in organic medium distinguish plasmonic properties. Surface plasmon resonance bands were obtained in all cases: Ag at 430 nm, Cu at 570 nm, Co at 350 nm (SPR1) and 430 nm (SPR2). Comparing theoretical evaluation of nanoparticles size with atomic force microscopy analysis, we can assume that our calculations are accurate. It was found that dominating nanoparticles diameter in Ag colloidal solution is ≈ 150 nm, in Cu colloidal solution is ≈ 7080 nm and in Co colloidal solution is ≈ 150 nm. It can be concluded that nanoparticles with enhanced plasmonic properties synthesized in organic medium can be widely used in order to increase eciency of various optical elements.
Synthesis and Characterization of Copper Nanoparticles using Different Concentration of
2019
New copper nanoparticles (CuNPs) have been synthesized via chemical reduction method in the presence of rice straw as supports and seaweed as a stabilizer. Characterizations of the CuNPs were carried out using UV-visible spectroscopy (UV-vis), Fourier Transform Infrared (FT-IR), Field Emission Scanning Electron Microscopy (FESEM), and Energy Dispersive X-ray (EDX). The UV-vis adsorption spectra confirm the formation of CuNPs through the peaks of the surface plasmon resonance (SPR) bands around 500 to 600 nm. Morphological characterization showed the formation of a spherical structure of the CuNPs. Similarly, EDX spectra showed that the nanoparticles produced are copper based. The size of nanoparticles formed by this method was controlled easily by using different concentration of rice straw.
Amorphization of Cu nanoparticles: Effects on surface plasmon resonance
Applied Physics Letters - APPL PHYS LETT, 2011
Crystalline copper nanoparticles (NPs) were formed in silica by multi-energy MeV ion implantations and then transformed to amorphous NPs by irradiation with 5 MeV Sn3+ ions. Optical absorption spectra of both the phases were evaluated in the ultra-violet to near-infrared regions. Compared with corresponding crystalline NPs of the same mean diameter, the amorphous NPs showed a low-energy shift of the surface plasmon resonance around 2.2 eV and less prominent absorption structure around 4 eV. These differences are explained by a strongly reduced electron mean-free-path in the amorphous NPs due to the loss of lattice periodicity.