Wrap on overflow - MATLAB & Simulink (original) (raw)

Main Content

Select the diagnostic action to take if the value of a signal overflows the signal data type and wraps around.

Category: Diagnostics

Default: warning

none

Simulink® software takes no action.

warning

Simulink software displays a warning.

error

Simulink software terminates the simulation or code generation and displays an error message.

This diagnostic applies only to overflows which wrap for integer and fixed-point data types.
This diagnostic also reports division by zero for all data types, including floating-point data types.
To check for floating-point overflows (for example, Inf or NaN) for double or single data types, select the Inf or NaN block output diagnostic. (See Inf or NaN block output for more information.)
If a floating-point to integer or floating-point to fixed-point overflow is signaled, set the model parameterEfficientFloat2IntCast to 'off' to ensure that simulation and the generated code agree. See Remove code from floating-point to integer conversions that wraps out-of-range values (Simulink Coder) for more detail.
For models referenced in accelerator mode, Simulink ignores the Wrap on overflow parameter setting if you set it to a value other than None.
You can use the Model Advisor to identify referenced models for which Simulink changes configuration parameter settings during accelerated simulation.
1. In the Simulink Editor, in the Modeling tab, click Model Advisor, then clickOK.
2. Select .
3. Run the Check diagnostic settings ignored during accelerated model reference simulation check.
During code generation, Simulink may simulate a few blocks in the model for optimization purposes. If simulation of these blocks triggers this diagnostic to report an error, the software terminates code generation.

Parameter: IntegerOverflowMsg
Value: 'none' \| 'warning'	'error'
Default: 'warning'

Related Topics