Simulate Variant Subsystem with Startup Activation Using parsim - MATLAB & Simulink Example (original) (raw)

This example shows how you can simulate a Variant Subsystem with startup activation using parsim. You can simulate multiple configurations in parallel with the variant activation time set to startup using parsim. Each configuration will have one active variant.

Model

Open the model slexVariantSubsystemsWithParSim. The model contains a variant subsystem block Controller with two choices Linear Controller and Nonlinear Controller with the conditions VSS_MODE == 1 and VSS_MODE == 2 respectively. Set the Variant activation time to startup in the Block Parameters dialog.

open_system('slexVariantSubsystemsWithParSim.slx');

Step 1 - Set up the active variant selection for each variant choice

Set up the active variant selection for each variant choice and set the number of simulation run equal to the variant selections. In this example model, we have two variant choices.

mdl = 'slexVariantSubsystemsWithParSim'; % open_system(mdl); numSims = 2; varControl = [1,2];

Step 2 - Create the SimulationInput object

Create the SimulationInput object for each simulation run and set the variant control value for each run.

in(1:numSims) = Simulink.SimulationInput(mdl); for idx = 1:numSims in(idx) = in(idx).setModelParameter('SimulationMode', 'rapid', ... 'RapidAcceleratorUpToDateCheck', 'on', ... 'SaveTime', 'on', ... 'SaveOutput', 'on'); in(idx) = in(idx).setVariable('VSS_MODE',varControl(idx)); end

Step 3 - Use parsim to simulate the model

Use parsim to simulate the model in parallel for each variant control value.

out = parsim(in, 'ShowProgress', 'on');

[01-Feb-2025 16:20:49] Checking for availability of parallel pool... [01-Feb-2025 16:20:49] Running simulations...

Searching for referenced models in model 'slexVariantSubsystemsWithParSim'.

Total of 1 models to build.

Building the rapid accelerator target for model: slexVariantSubsystemsWithParSim

Successfully built the rapid accelerator target for model: slexVariantSubsystemsWithParSim

[01-Feb-2025 16:21:12] Completed 1 of 2 simulation runs

Searching for referenced models in model 'slexVariantSubsystemsWithParSim'.

Total of 1 models to build.

[01-Feb-2025 16:21:16] Completed 2 of 2 simulation runs

You can simulate the model using parsim with SetupFcn. This is optional. If you run parsim without SetupFcn, set the RapidAcceleratorUpToDateCheck to on.

out = parsim(in, 'ShowProgress', 'on', ...'SetupFcn', @() slexVariantSubsystemsWithParSim_script_setup(mdl));

The setup script, slexVariantSubsystemsWithParSim_script_setup.m builds the rapid acceleration target for the model.

Step 4 - Plot the output values

Now plot the results from each run.

for i = 1:numSims simOut = out(i); t = simOut.tout; y = simOut.yout; plot(t, y) hold on end