An Ultra Low-power and Traffic-adaptive Medium Access Control Protocol for Wireless Body Area Network (original) (raw)

TAD-MAC: Traffic-ware dynamic MAC protocol for wireless body area sensor networks

IEEE Journal on Emerging and Selected Topics in Circuits and Systems, 2012

A wireless body area sensor network (WBASN) demands ultra low power and energy efficient protocols. Medium access control (MAC) layer plays a pivotal role for energy management in WBASN. Moreover, idle listening is the dominant energy waste in most of the MAC protocols. WBASN exhibits wide range of traffic variations based on different physiological data emanating from the monitored patient. For example, electrocardiogram data rate is multiple times more in comparison with body temperature rate. In this context, we propose a novel energy efficient traffic-aware dynamic (TAD) MAC protocol for WBASN. The protocol relies on dynamic adaptation of wake-up interval based on a traffic status register bank. The proposed technique allows the wake-up interval to converge to a steady state for fixed and variable traffic rates, which results in optimized energy consumption. A comparison with other energy efficient protocols for three different widely used radio chips i.e. cc2420, cc1000 and amis52100 is presented. The results show that TAD-MAC outperforms all the other protocols under fixed and variable traffic rates. Finally lifetime of a WBASN was estimated and found to be 3 to 6 times better than other protocols.

Energy-Efficient Low Duty Cycle MAC Protocol for Wireless Body Area Networks

IEEE Transactions on Information Technology in Biomedicine, 2009

This paper presents an energy-efficient medium access control protocol suitable for communication in a wireless body area network for remote monitoring of physiological signals such as EEG and ECG. The protocol takes advantage of the static nature of the body area network to implement the effective time-division multiple access (TDMA) strategy with very little amount of overhead and almost no idle listening (by static, we refer to the fixed topology of the network investigated). The main goal is to develop energy-efficient and reliable communication protocol to support streaming of large amount of data. TDMA synchronization problems are discussed and solutions are presented. Equations for duty cycle calculation are also derived for power consumption and battery life predictions. The power consumption model was also validated through measurements. Our results show that the protocol is energy efficient for streaming communication as well as sending short bursts of data, and thus can be used for different types of physiological signals with different sample rates. The protocol is implemented on the analog devices ADF7020 RF transceivers.

A power efficient MAC protocol for wireless body area networks

2012

Applications of wearable and implanted wireless sensor devices are hot research area. A specialized field called the body area networks (BAN) has emerged to support this area. Managing and controlling such a network is a challenging task. An efficient media access control (MAC) protocol to handle proper management of media access can considerably improve the performance of such a network. Power consumption and delay are major concerns for MAC protocols in a BAN. Low cost wakeup radio module attached with sensor devices can help reduce power consumption and prolong the network lifetime by reducing idle state power consumption and increasing sleep time of a BAN node. In this article, we propose a new MAC protocol for BAN using out of band (on-demand) wakeup radio through a centralized and coordinated external wakeup mechanism. We have compared our method against some existing MAC protocols. Our method is found to be efficient in terms of power consumption and delay.

A Very Low Power MAC (VLPM) Protocol for Wireless Body Area Networks

Sensors, 2011

Wireless Body Area Networks (WBANs) consist of a limited number of battery operated nodes that are used to monitor the vital signs of a patient over long periods of time without restricting the patient's movements. They are an easy and fast way to diagnose the patient's status and to consult the doctor. Device as well as network lifetime are among the most important factors in a WBAN. Prolonging the lifetime of the WBAN strongly depends on controlling the energy consumption of sensor nodes. To achieve energy efficiency, low duty cycle MAC protocols are used, but for medical applications, especially in the case of pacemakers where data have time-limited relevance, these protocols increase latency which is highly undesirable and leads to system instability. In this paper, we propose a low power MAC protocol (VLPM) based on existing wakeup radio approaches which reduce energy consumption as well as improving the response time of a node. We categorize the traffic into uplink and downlink traffic. The nodes are equipped with both a low power wake-up transmitter and receiver. The low power wake-up receiver monitors the activity on channel all the time with a very low power and keeps the MCU (Micro Controller Unit) along with main radio in sleep mode. When a node [BN or BNC (BAN Coordinator)] wants to communicate with another node, it uses the low-power radio to send a wakeup packet, which will prompt the receiver to power up its primary radio to listen for the message that follows shortly. The wake-up packet contains the desired node's ID along with some other information to let the targeted node to wake-up and take part in communication and let all other nodes to go to sleep mode quickly. The

Energy Efficient MAC Protocols in Wireless Body Area Sensor Networks-A Survey

In this paper, we first presented an analytically discussion about energy efficiency of Medium Access Control (MAC) protocols for Wireless Body Area Sensor Networks (WBASNs). For this purpose, different energy efficient MAC protocols with their respective energy optimization techniques; Low Power Listening (LPL), Scheduled Contention and Time Division Multiple Access (TDMA), are elaborated. We also analytically compared path loss models for In-body, On-body and Off-body communications in WBASNs. These three path loss scenarios are simulated in MATLAB and results shown that path loss is more in In-body communication because of less energy level to take care of tissues and organs located inside human body. Secondly, power model for WBASNs of Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) and beacon mode is also presented. MATLAB simulations results shown that power of CSMA/CA mode is less as compared to beacon mode. Finally, we suggested that hybrid mode is more useful to achieve optimization in power consumption, which consequently results in high energy efficiency.

A Study of Medium Access Control Protocols for Wireless Body Area Networks

The seamless integration of low-power, miniaturised, invasive/non-invasive lightweight sensor nodes have contributed to the development of a proactive and unobtrusive Wireless Body Area Network (WBAN). A WBAN provides long-term health monitoring of a patient without any constraint on his/her normal dailylife activities. This monitoring requires low-power operation of invasive/non-invasive sensor nodes. In other words, a power-efficient Medium Access Control (MAC) protocol is required to satisfy the stringent WBAN requirements including low-power consumption. In this paper, we first outline the WBAN requirements that are important for the design of a low-power MAC protocol. Then we study low-power MAC protocols proposed/investigated for WBAN with emphasis on their strengths and weaknesses. We also review different power-efficient mechanisms for WBAN. In addition, useful suggestions are given to help the MAC designers to develop a low-power MAC protocol that will satisfy the stringent...

A-MAC: Adaptive Medium Access Control Protocol for Wireless Body Area Networks

Recent work in Wireless Body Area Networks (WBANs), specially modern health-care systems enable us to monitor human body with the help of wireless sensors (nodes). Nodes are provided with limited battery power and battery power is dependent on radio activity. MAC protocols play a key role to control the radio activity. Therefore, we present Adaptive Medium Access Control (A-MAC) protocol for WBANs supported by linear programming models for the minimization of energy consumption and maximization of data flow. Our proposed protocol is adaptive in terms of guard band assignment technique, and sleep/wakeup mechanism. We focus on specific application to monitor human body with the help of nodes which continuously scan body for updated information. If the current value is within normal range, nodes do not try to access channel. However, if the current value rise or fall beyond the permissible range, nodes switch on their transceiver to access channel. Moreover, A-MAC uses TDMA approach to access channel and well defined synchronization scheme to avoid collisions. Furthermore, we conduct a comprehensive analysis supported by MATLAB simulations to provide estimation of delay spread. Simulation results justify that the proposed protocol performs better in terms of network lifetime and throughput as compared to the counterpart protocols.

Article A Very Low Power MAC (VLPM) Protocol for Wireless Body Area Networks

2011

Wireless Body Area Networks (WBANs) consist of a limited number of battery operated nodes that are used to monitor the vital signs of a patient over long periods of time without restricting the patient's movements. They are an easy and fast way to diagnose the patient's status and to consult the doctor. Device as well as network lifetime are among the most important factors in a WBAN. Prolonging the lifetime of the WBAN strongly depends on controlling the energy consumption of sensor nodes. To achieve energy efficiency, low duty cycle MAC protocols are used, but for medical applications, especially in the case of pacemakers where data have time-limited relevance, these protocols increase latency which is highly undesirable and leads to system instability. In this paper, we propose a low power MAC protocol (VLPM) based on existing wakeup radio approaches which reduce energy consumption as well as improving the response time of a node. We categorize the traffic into uplink and downlink traffic. The nodes are equipped with both a low power wake-up transmitter and receiver. The low power wake-up receiver monitors the activity on channel all the time with a very low power and keeps the MCU (Micro Controller Unit) along with main radio in sleep mode. When a node [BN or BNC (BAN Coordinator)] wants to communicate with another node, it uses the low-power radio to send a wakeup packet, which will prompt the receiver to power up its primary radio to listen for the message that follows shortly. The wake-up packet contains the desired node's ID along with some other information to let the targeted node to wake-up and take part in communication and let all other nodes to go to sleep mode quickly. The

A low power medium access control protocol for wireless medical sensor networks

The 26th Annual International Conference of the IEEE Engineering in Medicine and Biology Society, 2004

The concept of a wireless integrated network of sensors, already applied in several sectors of our everyday life, such as security, transportation and environment monitoring, can as well provide an advanced monitor and control resource for healthcare services. By networking medical sensors wirelessly, attaching them in patient's body, we create the appropriate infrastructure for continuous and real-time monitoring of patient without discomforting him. This infrastructure can improve healthcare by providing the means for flexible acquisition of vital signs, while at the same time it provides more convenience to the patient. Given the type of wireless network, traditional Medium Access Control (MAC) protocols cannot take advantage of the application specific requirements and information characteristics occurring in medical sensor networks, such as the demand for low power consumption and the rather limited and asymmetric data traffic. In this paper, we present the architecture of a low power MAC protocol, designated to support wireless networks of medical sensors. This protocol aims to improve energy efficiency by exploiting the inherent application features and requirements. It is oriented towards the avoidance of main energy wastage sources, such as idle listening, collision and power outspending.

Towards Power Efficient MAC Protocol for In-Body and On-Body Sensor Networks

Lecture Notes in Computer Science, 2009

This paper presents an empirical discussion on the design and implementation of a power-efficient Medium Access Control (MAC) protocol for in-body and on-body sensor networks. We analyze the performance of a beacon-enabled IEEE 802.15.4, PB-TDMA, and S-MAC protocols for on-body sensor networks. We further present a Traffic Based Wakeup Mechanism that utilizes the traffic patterns of the BAN Nodes (BNs) to accommodate the entire BSN traffic. To enable a logical connection between different BNs working on different frequency bands, a method called Bridging function is proposed. The Bridging function integrates all BNs working on different bands into a complete BSN.