Gilding | Gold Leaf, Silver Leaf & Metal Leaf | Britannica (original) (raw)

gilding, the art of decorating the whole or parts of wood, metal, plaster, glass, or other objects with gold in leaf or powder form. The term also embraces the application of silver, palladium, aluminum, and copper alloys.

The ancient Egyptians were master gilders, as evidenced by the overlays of thin gold leaf on their royal mummy cases and furniture. From early times the Chinese ornamented wood, pottery, and textiles with beautiful designs in gold. The Greeks not only gilded wood, masonry, and marble sculpture but also fire-gilded metal, by applying a gold amalgam to it and driving off the mercury with heat, leaving a coating of gold on the metal surface. From the Greeks, the Romans acquired the art that made their temples and palaces resplendent with brilliant gilding.

Certain basic procedures are pertinent to all types of gilding. For example, the ground to be gilded must be carefully prepared by priming. Flat paints, lacquers, or sealing glues are used, according to the nature of the ground material. Metals subject to corrosion may be primed, and protected by red lead or iron oxide paints. After the ground has been prepared and is thoroughly dry, the gilder lays out his design on the ground with pencil or chalk. To create an adhesive surface, the area to be gilded is sized. The type of size used depends on the kind of surface to be gilded and on whether it is desirable for the size to dry quickly or slowly. When the size has dried enough so that it just adheres to the fingertips, it is ready to receive or retain the gold leaf or powder.

More From Britannica sculpture: Gilding

Beating gold into leaves as thin as 1⁄280,000 inch (0.00009 millimetre) is done largely by hand, although machines are used to some extent. The beaten leaves are packed between tissue leaves of small books. Gold leaf may be rolled onto the sized surface from the tissue book. Generally, however, the gilder detaches the amount needed with a pointed tool, picks it up with a gilder’s brush, and transfers it to the design. The leaf is held to the tip by static electricity, which the gilder generates by brushing the tip gently over his hair. When the gilding is completed, the leaf-covered area is pounced with a wad of soft cotton to burnish the gold to a high lustre. Leaf gold may be powdered by being rubbed through a fine-mesh sieve. Powdered gold is so costly, however, that bronze powders have been substituted almost universally. Metallic powders may be pounced on a sized surface with a soft material such as velvet or may be combined with a lacquer or with a chemical base and then applied as metallic paint.