Injection of point defects during annealing of low energy As implanted silicon (original) (raw)
Related papers
Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1999
Cracks and blisters formed close to a silicon wafer surface by He-H co-implantation at low energy
Journal of Applied Physics, 2015
Dose rate effects on the dynamic annealing mechanism in P+ -implanted silicon
physica status solidi (a), 1986
Interstitial injection during oxidation of very low energy nitrogen-implanted silicon
Materials Science and Engineering: B, 2005
Onset of blistering in hydrogen-implanted silicon
Applied Physics Letters, 1999
arXiv (Cornell University), 2023
Sulfur point defects in crystalline and amorphous silicon
Physical Review B, 2004
Formation of silicon ultra shallow junction by non-melt excimer laser treatment
Solid-State Electronics, 2010
2007
Second-order generation of point defects in highly irradiated float zone silicon—annealing studies
Physica B: Condensed Matter, 2003
Porous silicon fabrication technique for large area devices
Review of Scientific Instruments, 1996
The fabrication of silicon nanostructures by focused-ion-beam implantation and TMAH wet etching
Nanotechnology, 2010
A Technique for Delineating Defects in Silicon
Solid State Phenomena
Burst annealing of electron damage in silicon solar cells
Recovery of the carrier density in arsenic-doped silicon after high energy (2 MeV) Si+ implantation
Journal of Applied Physics, 2004
Defect production in strained p-type Si1−xGex by Er implantation
Journal of Applied Physics, 2011
Comparison of the structures of evaporated and ion-implanted amorphous silicon samples
Journal of Physics: Condensed Matter, 2005
Fabrication of SiGe rings and holes on Si(001) by flash annealing
Applied Surface Science, 2013
Amorphous-silicon devices start to shape up
Microelectronics Reliability, 1983
Modification of a post-implantation defect activity for photovoltaic conversion
Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1999
Gettering impurities from crystalline silicon by aluminum diffusion using a porous silicon layer
physica status solidi (c), 2005
Radiation-enhanced diffusion of Sb and B in silicon during implantation below400°C
Physical Review B, 2004
Replenish and Relax: Explaining Logarithmic Annealing in Ion-Implantedc-Si
Physical Review Letters, 2013
Modeling of ultra-low energy boron implantation in silicon
International Electron Devices Meeting. IEDM Technical Digest, 1997
IBIC Studies of structural defect activity in different polycrystalline silicon material
Vacuum, 2003
The influence of charge states and elastic stresses on the diffusion of point defects in silicon
Materials Science and Engineering: B, 2003
Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1999
Damage to Crystalline Silicon Following Implantation by Low Energy Silicon Ions
MRS Proceedings, 1992
Estimation of the Number of Interstitial Atoms Injected in Silicon during Thin Oxide Formation
Journal of The Electrochemical Society, 1999
Robustness of amorphous silicon during the initial lithiation/delithiation cycle
Journal of Power Sources, 2014
Manufacturing of Silicon Solar Cell
Anode hole injection and trapping in silicon dioxide
Journal of Applied Physics, 1996
Arsenic redistribution at the SiO(2)/Si interface during oxidation of implanted silicon
1998
Nanotechnology, 2009
Oxygen-induced broken-bond defect in silicon
Physical Review B, 1992